Question about Miele Dishwashers

Open Question

Miele g575 pump still running - Miele Dishwashers

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 4 Answers

SOURCE: Miele G575

This sounds like the overflow trip switch has been activated. Some time back I had this problem with a Miele G664. The service man undid 4 screws on the door and removed front panel and found water in the drip tray, He then checked the pipes, outlet pipe had a pice of plastic bread tag stuck in it , this was slowing down the time it took to empty the water and the next fill made it overflow and switch off the dishwasher. He cleaned out the chanel on the overflow that was full of dust and fluff checked the levels to make sure the dishwasher was sitting true. Closed it all up and ran the dishwasher. Perfect!

Bill $160. It did take him the best part of an hour and I live a long way out of town.

Posted on Oct 10, 2008

Ad
Obertelli

Obertelli

  • 3006 Answers

SOURCE: What kind and how much salt goes into my miele

Straightforward, coarse, dishwasher salt (sodium chloride). Regular table salt is far more expensive and because it's not coarse it clogs when pouring it in.

Just pour salt into the salt chamber until it's full and screw the lid back on.

Posted on Mar 15, 2010

Sam

  • 3247 Answers

SOURCE: water levil to high on

It is possible that there is a block in the drain hose which prevents water from previous wash to fully empty.
This means when you start dishwasher next time it overflows and causes the dishwasher flood switch to trip and shut dishwasher.

You will need to check the drain hose for any blockages and clear it.

Posted on Mar 11, 2011

Martin Bauer

  • 1 Answer

SOURCE: miele G575 Dishwasher

If the water level is not adjusted at the right level
(see Miele G 575 manual page 29),
the flap doesn't open at the right circle,or doesn't open at all.
(Cause of the low water level the machine makes more noise!)
======Now shut down the power for the machine!!!=============
To adjust the water level new,you have to open the shield(2 screws) under the
main door.(enginen compartment).(You don't have to move the machine!)
On the right ,right,right,hand side,there is a 6 cm round beige plastic box.
(the first thing you see to you right and very easy access)
Only one black water hose(about 1cm=1/4inch) and a few wires are going into this box.
This is the water level adjustment box.
In the middle of the beige plastic box is a beige plastic screw
to adjust the water level new.Turning it clock vise ,increasing
the water level.
(For the right water level,see page 29 in your G575 Miele manual)
The water level hasn't to be super price.Just in about and enough.
(It seems that the rubber membrane in the water level unit ages
and therefor it has to be readjusted after a longer time)

Posted on Feb 06, 2012

ercupa190

ernesto cuadra

  • 12223 Answers

SOURCE: My g575 miele dishwasher will not fill with water until the end of the dry cycle.. help

see this possible fault:Water-inlet valve
the valve is defective, test and replace it see how.
Float switch
had been fail, replace see how to test it, and see the diagram

6_9_2012_4_14_15_pm.gif6_9_2012_4_14_46_pm.gif

Posted on Jun 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Our Miele G575 dishwasher element looks good but doesn't always heat up....


If you have power going to the element and it stays cold, the element is faulty.

Nov 27, 2017 | Miele Dishwashers

1 Answer

My g575 miele dishwasher will not fill with water until the end of the dry cycle.. help


see this possible fault:Water-inlet valve
the valve is defective, test and replace it see how.
Float switch
had been fail, replace see how to test it, and see the diagram

6_9_2012_4_14_15_pm.gif6_9_2012_4_14_46_pm.gif

Jun 09, 2012 | Miele Dishwashers

1 Answer

What kind and how much salt goes into my miele G575 dishwasher?


Straightforward, coarse, dishwasher salt (sodium chloride). Regular table salt is far more expensive and because it's not coarse it clogs when pouring it in.

Just pour salt into the salt chamber until it's full and screw the lid back on.

Mar 15, 2010 | Dishwashers

1 Answer

Does anyone have a service manual for the Miele G575 dishwasher?


Check the bottom floor pan, if water is there, only the drain will operate. Sometimes the float switch, which is a styrofoam block, gets warpped and activates the switch. This turns on the drain pump which overrides everything.

Sgt 48

Mar 28, 2008 | Miele 24 in. G656SCi Plus SS Built-in...

2 Answers

Miele G575 slow and insufficient water fill


The unit has a double valve system, the waterproof, it could be that one of the valves is not opening fully. They can break down over time. This would mean you need a new one. This should fix the problem.
Open the door once the wash has started and check the water level. It could be that it is siphoning out half way through the wash. Make sure your drain hose is secured up properly.
If when you open the wash and there is not enough water, it is most likely the waterproof, as I stated before.
cheers.

Sgt 48

Oct 30, 2007 | Miele 24 in. G656SCi Plus SS Built-in...

2 Answers

Dishwasher Miele G575


It could be a motor or a pump issue. The dishwasher has a motor that attached to a pump which forces the water up into the sprayer arms and during the drain cycle, it pushes the water out of the dishwasher. The motor (and pump) located beneath the dishwasher. Regarding the screwdriver adjustment- This is the rinse aid dosage adjuster. To obtain the best drying results,use the selector on setting 5. When dishes show spots, set it to a higher setting. Turn lower if dishes are cloudy. Good luck!

Sep 13, 2007 | Miele 24 in. G665 Built-in Dishwasher

2 Answers

Miele G575


This sounds like the overflow trip switch has been activated. Some time back I had this problem with a Miele G664. The service man undid 4 screws on the door and removed front panel and found water in the drip tray, He then checked the pipes, outlet pipe had a pice of plastic bread tag stuck in it , this was slowing down the time it took to empty the water and the next fill made it overflow and switch off the dishwasher. He cleaned out the chanel on the overflow that was full of dust and fluff checked the levels to make sure the dishwasher was sitting true. Closed it all up and ran the dishwasher. Perfect!

Bill $160. It did take him the best part of an hour and I live a long way out of town.

Apr 30, 2007 | Miele 24 in. G656SCi Plus SS Built-in...

Not finding what you are looking for?
Dishwashers Logo

Related Topics:

170 people viewed this question

Ask a Question

Usually answered in minutes!

Top Miele Dishwashers Experts

mpservices

Level 2 Expert

190 Answers

Mike

Level 3 Expert

4367 Answers

Cindy Wells

Level 3 Expert

6065 Answers

Are you a Miele Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...