20 Most Recent
Miele 24 in. G892SCU Plus Built-in Dishwasher Questions & Answers
I have a G 892 SCU Plus dishwasher and the intake
I removed filter basket and under it there was a small chrome rod prodruding horizontally by about 3cm. I pushed this in and restarted the machine. Although the light flashed when I first switched on it went out when I started the prograamme. It is working fine now.
WON'T TURN ON. PLUGGED IN
Unplug the washer and get a short HD extension cord and plug in to another KNOWN good (has power) outlet. Or plug in a small appliance where the washer was plugged in and see if it works. Designated outlet for washer could be defective. Never work on electrical devices until you have the correct breaker switched OFF. Good luck, best regards.
Miele Dishwasher - Not cleaning
Hi,
I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...
Dishwasher Spray Arms not SpinningHow to Buy Appliance Parts OnlineA bad heating element causes many problems in dishwashers...Dishwasher Problems The Heating Element not WorkingDishwasher Maintenanceheatman101
xxz
No power. No lights on panel. Won't turn on
Hi
Thanks
for using FixYa. The issue is with the control
panel going bad and should be replaced. However, before replacing the control
panel try to blow some air with the help of hair dryer, if still it’s not
resolved then replace the control panel. Please do
accept the solution if the issue is resolved or post a comment for further
assistance.
Thanks
Rylee
Intake/drain light flashes and the dishwasher
hi,
this is a general fault light which could mean anything without a Miele Technician coming out and connecting a laptop to the unit. However most common faults with dishwashers is a drain fault. Check for any kinked hoses and check the drain spigot under the sink where the drain hose connects into the u bend. Usually this is where food gets trapped due to the spigot not being drilled out large enough. This then causes a blockage. Also check the non return valve under the filter and make sure the drain pump can turn freely.
Hope this helps.
Only Upper basket and cutlery basket wash
got a bargain here ,a miele ?? the rolls royce of machines ,cant say i have repaired one of these myself but if no water from bottom spinner then i am sure it could be the programmer like you suspect and a solonoid operated valve ,most likely fault is the programmer so by pass the valve and just use the ,main wash and never mind about the top only cycle .If it is the programmer then no doubt it would cost more than a new cheap machine so the previous owner sold it ,like a second hand car if it plays up put it in auction
Not finding what you are looking for?