Error code SC922 or SC992 mean? - Ricoh Aficio 450 Copier

SC992-00

An error not controlled by the system occurred (the error does not
come under any other SC code).

Software defective
Turn the machine power off and on. The machine cannot be used
until this error is corrected.
Re-install firmware

So try flash firmware. tell me if you need help for that

Software error 3: Undefined An error not controlled by the system occurred (the error does not come under any other SC code

what make and model printer is it?

Error Code 4001

System error code 4001 means "The local WINS cannot be deleted." This error code may also display as "ERROR_CAN_NOT_DEL_LOCAL_WINS" or as the value 0xFA1.

Error Code 4002

System error code 4002 means "The importation from the file failed." This error code may also display as "ERROR_STATIC_INIT" or as the value 0xFA2.

Error Code 4003

System error code 4003 means "The backup failed. Was a full backup done before?" This error code may also display as "ERROR_INC_BACKUP" or as the value 0xFA3.

Error Code 4004

System error code 4004 means "The backup failed. Check the directory to which you are backing the database." This error code may also display as "ERROR_FULL_BACKUP" or as the value 0xFA4.

Error Code 4005

System error code 4005 means "The name does not exist in the WINS database." This error code may also display as "ERROR_REC_NON_EXISTENT" or as the value 0xFA5.

Error Code 4006

System error code 4006 means "Replication with a nonconfigured partner is not allowed." This error code may also display as "ERROR_RPL_NOT_ALLOWED" or as the value 0xFA6.

System Error Codes

922 B IMB DRAM error
The machine detects a discrepancy in
the IMB DRAM write/read data during
its write/read test (done at power off/on
and at recovery from low power or
night/off mode).
• IMB defective
• BiCU defective
• Poor connection between BiCU an IMB
might be time to replace copier for what it cost to fix it.

The best way is to update the firmware in the copier. You have to download the current firmware and put it on a flash card and and plug it in to port 2 after powering down the copier. Power it back on and the firmware will set itself up to your copier.

sc922 can be caused by:

1. Poor connection between IMB ab Bicu
2. IMB defective
3. Bicu defective

unplug the machine from the power source, you need to remove the Dram and the IMB and reinstall again, becareful don't touch the Dram and the IMB with your fingers you can damadge them by your body electrostatic charge.

There is no sc922 for the CL1000N, but sc992 is a general software error. It typically shouldn't interrupt operation, but it if it does and it happens more than once, try to figure out what you were doing when it happened. Were you printing a big job? Were you printing a job with a particular font? Does it always happen at a certain time of day? Narrowing down the conditions can help to figure what is causing the error code.

Hello sir; It's means waste toner bottle full, dump it after you turn off the power, then turn power back on.

error code 3501 means the front access door is open on the printer. Error code 3502 means the paper tray is empty. The error code 3602 means the print job did not finish printing.

for more hrlp visit CBR Tech Solutions