Optical Mouse Model AM-3055U will not work on this computer

It four zero 0000

get on the manufacturers web site for the mouse , find the download for your model and download it
win 7 is no longer supported by Microsoft so any late drivers will not be installed in that os

Hi, you'll need a USB receiver in order for the mouse to work with a computer. The USB receiver connects to the computer and transmits the mouse's movements and clicks to the motherboard. Without the receiver, your computer has no way to know what the mouse is doing.
You can purchase replacement receivers for many kinds of wireless mice, but for the price it will cost you are probably just better off buying a brand new mouse so that you know it will work correctly with the receiver.

Try downloading the driver in your computer again. The registry file can be corrupt from other downloads. It has happened to mine twice so far in two years The drivers can be found at this link below...Remember I do not know what model you have so a 3000 & a 4000 model link for each are showing for you below here

http://www.softwaredriverdownload.com/microsoft_wireless_notebook_optical_mouse_3000_driver.html

http://www.driverfiles.net/Input-Devices/Microsoft/Wireless-Notebook-Optical-Mouse-4000/download/page,sh,28746,138,20,.html

if ur driver is ok, then u try first to restart ur system or properly shut down ur laptop them plug ur mouse carefully.........

why use a floppy disk when u can use a flash drive and boot off it ?

see the very first thing is that what u can try is that try and connect the same mouse that u had and that had worked and if works then the prob is with the mouse that u have right now and if that also doesnt work then the usb port on the laptop has gone bad and u need to replace the motherboard of the computer but before replacing the motherboard try and connect some other usb device on the same usb port.........

Normal 0 Press the Receiver button (and the lights will start flashing.
Then if the Keyboard isn't working, press the small RESET/CONNECT button on the back of the board to connect the keyboard to the receiver.
Hope this helps. Bud