Xerox workcentre 6015 ni error code 092-651 - Xerox WORKCENTRE 6015/Ni Color

SOURCE: reset WorkCentre 24, Xerox

In menus you browse to the service tab, then serivice diagnostics. Go to NVRAM reset and perform the NVM reset.
Before you do that, print out a configuration page if you want to rememebr the network settings. It will set the IP address back to default also.

SOURCE: Xerox WorkCentre M128 - 016 - 782

There is an error in the in the server password or a template setting.
Here is the documentation. Pretty straight forward

Login to the Server was not possible during Scan to Server file transfer.
Initial Action Refer to BSD 16.1.
Power OFF/ON
Procedure Set the login name and password in the destination server.
Set the attributes of the Job Template file correctly.
From a client PC, set the same account as the above as a resource using CW.

SOURCE: Xerox WC Pro 35 - Error 14-563

this code means your scanner has failed to setup correctly. this could be a problem that you would need a qualified tech to service the copier. there is nothing that you can do after you power off and power on (popo) the copier. it could be voltage, pwb board, or a binding scanner assembly.

SOURCE: LSU Error

Hi Dear
I am facing LSU Error on my Xerox workstation PE 220

I am not able to do anything, please let me wat to do

i have lot of work penindg

urs

mujahid

SOURCE: workcentre c2424 is showing system error 39,003.40:117010

That is a document feed or scanner fault. Often times it is simply that molex connector working loose. It is the connector mounted vertically next to the main power cord on the right rear side of the machine. That bottom screw can be dificult to tighten. What I would try first is to shut the machine off, unscrew and disconnect that conntecot totally then firmly slide it in and get both the top and bottom screwss tight. Like I said, the bottom thumb screw can be hard to tighten even with a screw driver because it is a pretty soft rubber the tighteners are made out of.
If that doesnt work. go to the back and disconnect the document feed to scanner cables and reconnect. Other than that, you pretty much have to replace the feeder/scaner assembly since very very few parts are spared for that .