Traeger Industries BBQ075 All-in-One Grill / Smoker Logo
A
Anonymous Posted on Mar 03, 2014

Does not heat to right temp. - Traeger Industries BBQ075 All-in-One Grill / Smoker

1 Answer

Ernest Taliaferro

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Novelist:

An expert who has written 50 answers of more than 400 characters.

Scholar:

An expert who has written 20 answers of more than 400 characters.

  • Expert 197 Answers
  • Posted on Dec 10, 2014
Ernest Taliaferro
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Novelist:

An expert who has written 50 answers of more than 400 characters.

Scholar:

An expert who has written 20 answers of more than 400 characters.

Joined: Jul 11, 2013
Answers
197
Questions
0
Helped
65962
Points
278

You didn't give any specifics which makes it difficult to respond because there are many reasons why a Traeger grill might not heat to the right temperature.

One of the most common is problems is the outside temperature. If it's hot, the Traeger may overheat unless it is tended constantly. When it's cold, the Traeger may not get as hot as it should based on a normal setting and you may have to set it higher to reach the temperature you want.

Other reasons could be mechanical in that the hot rod may not be keeping the firebox as hot as it should or the fan may not be running as hard as it should to get the temperature to the right setting.

If your firebox has not been cleaned, ash will effectively insulate the fire, preventing heat from building up in the cooker.

Some people clean their Traeger thoroughly after every use. Some never clean theirs until something goes wrong. I clean mine after every 4-6 uses, depending on how long my cooking sessions have been.

If I've been cooking pork shoulder low and slow for many hours, I'll clean it more often than if I had grilled steaks multiple times for 15-20 minutes at a time.

Likely, if you're cooking in "normal" outside temperature of 60-80 degrees, your Traeger should be holding fairly close to the temperature you've set. If it's not then you may have a fan or hot rod problem and you ought to contact Traeger to set what they suggest.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

How to reset Kenmore Elite 665-16572202 Dishwasher...clean light blinks 7 times pauses then repeats. My model does not have a Heated Dry button it has an Air Dry button.

Here's the key sequence(s) to use, depending on how your keys are labeled:
Heated Dry - Normal - Heated Dry - Normal; or
High Temp - Air Dry - High Temp - Air Dry; or
Hi Temp Scrub, Energy Saver Dry, Hi Temp Scrub, Energy Saver Dry; or
High Temp Wash, Heated Dry, High Temp Wash, Heated Dry.

This will start the diagnostic cycle. Let the dishwasher run for a few minutes, and then press Cancel to stop the dioagnostic cycle and clear the error. Please note, that this clears the error, but if you haven't found the cause (water-not-heating error), the condition will come right back the next time you run the dishwasher.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

0helpful
1answer
0helpful
1answer

What is the sequence to reset kenmore dishwasher 665.16719000? The buttons from left to right are pots/pans, normal wash, water miser, china gentle, quick rinse, high temp, air dry, delay wash, start

Press "high temp wash, heated dry, High temp wash, heated dry, high temp wash, heated dry, high temp wash, heated dry, high temp wash"

All the lights will go solid at which point you press cancel to reset the board.

**NOTE** if you don't have a "heated dry" button, use the "air dry" or "energy saver dry" button instead.
0helpful
1answer

My 2001 buick lesabre does not blow heat. a/c works great. when switch to heat, it gives a quick burst of heat and then cool air. engine coolant temp is normal right around 200*F. Any suggestions?

under hood feel the heater hose temp they need to be the same temp very hot. if ok
check for the blend or mix door not opening
you can remove the actuator motor and move trap manually to see if stuck
0helpful
1answer

Ge gas oven jgbp28dej3ct.. oven pre heats good to right temp but wont maintain temp during cooking.

Hi,
If your electric oven is taking too long to heat or just not heating up right,then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101
0helpful
1answer

Over will not heat up beyond 175F, according to temp display enven when high temp selected. When Self cleaning selected oven does not heat up ,


Hi,


If your electric oven is taking too long to heat or just not heating up right, then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101

1helpful
1answer

I have a new bryant 2.5 ton 410 puron heat pump and it shut off when the temp get cooler. The temp right now is around 36. Is there anyway to get it to shutoff at a lower temp. so the aux heat won't kick...

Heat pumps only work down to a certain temperature, 35-40 degrees outside temp. Once it gets that cold the system cant pull any heat from the outside air and the aux heat kicks in to make up the differance.
0helpful
1answer

TB8220U Commercial Thermostat keeps running when temp is right

the temp coming out of the vent should be 20 to 25 deg more then room temp and if AUX heat kicks in the temp should be even more.
Not finding what you are looking for?

845 views

Ask a Question

Usually answered in minutes!

Top Traeger Industries Grilling Experts

Paul Carew

Level 3 Expert

3808 Answers

Brad Brown

Level 3 Expert

19187 Answers

Kardoc

Level 3 Expert

7503 Answers

Are you a Traeger Industries Grilling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...