Wont start It is stuck in dell lugu wiew when up start

It's a boot anchor.

To determine if your hard drive is bad or good, run the Dell diagnostics.
Here is a link for the owner's manual of your model:
ftp://ftp.dell.com/Manuals/all-products/esuprt_laptop/esuprt_xps_laptop/xps-m1210_owner%27s%20manual_en-us.pdf

Try the next oldest restore point until the issue is resolved. Any software installed after the selected restore point needs to be reinstalled.
If system restore still doesn't work, run the "Pre-Boot System Assessment (PSA) Diagnostics and Error Codes For Dell Computers", you may click the link below to go directly to the support site, it contains instructions in running PSA Diagnostics and Error Code List with possible fixes.
http://support.dell.com/support/topics/global.aspx/support/kcs/document?c=us&l=en&s=dhs&docid=266787#Issue2
Hope this helps.

Hello, if your computer peeps on startup it could be that your keyboard is stuck somehow thats why it beeps, it is sending and interupt request. try checking your keyboard to be sure its not stuck. happy new year

Telephone Dell. They can supply a set of "System Restore" CDs, and ship the disks to you.

You'll need to give them the unique Dell Asset Tag code (black type on a white sticky note, stuck to the back or bottom of the computer).

First check to see if any of the buttons are stuck. If that doesn't help, try a few simple things with the digitizer, the thing you write on. It could be stuck.If there are any gouges, dents, deep scratches or cracks, that could do it, it's toast - but self repairable if you dare. -However- 2 things to try first just for giggles though if there are no cracks: #1. Use your joystick & enter button to navigate through the Start Menu to Settings>>System>>Screen>> Align Screen and align the screen. Worth a try. #2. There might be some crud stuck between the edge of the digitizer and the edge of the case. That can give you phantom key presses. Take a piece of stiff paper or thin plastic and run it *gently* around under the edge where the case covers the screen to scoop out any stuff that may have settled there. Those blister packs that cut you up when you try to open them works well, credit card is too thick for my taste. #3. If it's been around water, there's a very slight chance that putting it on top of the clothes dryer for a few loads will dry it out.Beyond that, needs technical help.

It seems to be an issue with the Print Spooler Service. Either the service is stopped or not started correctly. Try stopping and restarting the printer spooler services on your computer. For tips on how to restart the Print Spooler service, use the link: http://www.ehow.com/how_2319117_restart-print-spooler-xp.html. Now Reboot your system and try deleting the print queue. It should work fine now.

Good Luck!
-Abhishek

Try to press the mode buttom. The display should wiew MAN for manual mode. There are usually three modes FAX ,FAX/TEL and MAN.

two things
1 remove and reinstall your memory
2 install a new bios for your motherboard

mustafa malik free software downloud plz