Dead JBL EON 15P-1

Hello Dane, if the fuse is good, you can have the speaker and driver of the horn, open, therefore it will not sound

Hola Dane, si el fusible esta bien, puedes tener el parlante y el driver de la bocina, abiertos, por lo tanto no va a sonar

Sounds about right to me. I have 2 eon G-15s. If you don't hear any cracking sounds you should be ok.

I’m happy to help further over the phone at https://www.6ya.com/expert/phillip_293d34ebcf028794

If you can watch the fuse kind of twitch. Most likely you have somthing shorted in your output amps. ( the ones on the heatsink underneath PCB) you'll probolly need a tech for this one to change out the transistors. Still under warranty?

you will get the fuse from all electrical shops and see to it that it has having the same power

you want JBL Professional group if this involves the Eon product line.

1-800-852-5776

Or on the website

http://www.jblproservice.com/

These are "powered" speakers and any little bit
of distortion can be amplified enough to "blow" it!
Also the amp could be "shorted"! Have your JBL
dealer test it!!!

There is nan internal fuse right behind the board were you plug the power cable in. You have to split the cabinet to replace.

the eon woofer is designed to fit the small frame of the inside cabinet. The EV woofers look too deep to fit but you can try. I do think that the built in amps were set to work with only the JBL woofers so there might be a signal problem using the built in amp. The eon face seems to have their own screws to hold the grill so if they aren't holding you can drop some cement to help hold the srews in place. The front does not allow removal of the woofer so it seems whatever you do should not effect anything.

These fuses are most likely 3 Amp fuses. Please note that if the replacements blow as well, that there is a problem within the amp section that will require repair.

Dan