DO NOT HAVE A USER MANUAL- AHARP XR-11XC MULTIMEDIA DLP

Hold down 'Enter' on the projector for about 5 seconds.

try going to Best Buy and tell them your problem!!

go into your menu and check the ceiling mount box

According to pg. 45 in the owner's manual, you turn Keylock function ON by holding down the ENTER key on the projector for about 5 seconds while the projector is being turned on.

To take the Keylock off-- Hold down the ENTER key on the projector for about 5 seconds. If the projector is in standby mode, you can release the keylock by holding down ENTER and STANDBY/ON keys simultaneously for about 5 seconds.

I opened mine up hit the red reset in the front and now all good. If ur red light is blinking make sure ur lamp compartment is shut properly, if not the red light will blink and unit won't turn on.

the colorwheel may be bad. if it doesn't spin, the lamp won't strike. if the colorwheel is ok, replace the power supply/ballast. you can get one and do it yourself, or send it to a sharp service center. either way, try www.avsolutionsny.com. they're really good.

try av solutions in ny. they're a sharp service center. www.avsolutionsny.com

reset the lamp timer. hold down the menu, down arrow, and enter buttons, then press power.

Sounds like your connection is bad, check ur connections on ur cables

Hi traks137

You will have to reset both the lamp and filter timer before it will change the status of this unit.

Your user manual will have all the steps in it on how to do the required resetting.

Thanks for using Fixya !