20 Most Recent
Milwaukee Tool Case Heat Gun - Page 3 Questions & Answers
Front axle
replace the wheel baring or the hole wheel,lubricate the wheel-shaft.
I have a pto shaft
Take the gears out.Bell housing side of pto shaft, insert punch in hole and use allen wrench to remove plug on shaft end. use punch in allen screw hole to drive shaft out of housing (don't mess up the threads!!)
I NEED THE VALVE CLEARANCE
Hi gabriele_vig,
Welcome to fixya!
The clearance for the inlet valves is 0.010". The exhaust valve clearance is .0.12".
Please place a vote when you accept this solution. Thanks,
Handie Andie
Case int 895 power steering
If you disconnect the hose fitting and remove the grommet in the body, the hose should then fit through, unless there is a plate/s that you can remove to enlarge the access to the pipe. The question and pictogram are a bit misleading and that may be the reason for the lack of response to date.
Hello i have a case
Hi,
The clutch is slipping....
There could be a number of things that can cause this...
Here is a discussion that will shed more light on this for you...
http://www.tractorbynet.com/forums/case-ih/169297-case-1494-hydraulic-problems.html
heatman101
Not finding what you are looking for?