20 Most Recent
Whirlpool Duet 7.0 Cu. Ft. Super Capacity Plus Electric Dryer - Page 3 Questions & Answers
How are the Whirlpool Duet washer & dryers serviced? From the front or the back
you have to pull it out,this code means you're having prblems with the washer filling,most likely it will be the water valve but i would shut the water off,take the lines off of the washer,stick them into the washer or a bucket and turn the water on,if the water comes out then you know it's the washer and you need to change out the water valve on the washer.
Control locked.
Hello & Welcome to FixYa
This is a common issue with Whirlpool Duet washer
however, your whirlpool duet washer needs a reset to resolve the control lock
problem. Press and hold the END OF CYCLE button for 15 seconds to reset the
control. Please get back to me if you have any other questions.
Kevin
Whirlpool duet dryer
When the dryer is not is use, it is recommended to leave the dryer door open. What you are experiencing is probably due to outside air coming back thru the dryer vent (the louvers don't always close well due to lint). The temperature difference between the outside air that accumulates in the dryer and the inside air causes condensation.
Replace broken flapper in lint screen slot.
it has been a while since I worked on one of these but if I remember there are 5 screws to remove 3 on door opening on front and two that r on back side of screen holder that have to be removed then u can take the whole thing out to put new flapper in.
Broker parts in dryer slot
Are you talking about the little door that closes when you pull out the lint screen, then opens when you put the screen back in? Did you get all the parts out of it when it broke? If so they put that in there to keep stuff from going down into the fan housing in case the filter was left out by accident. If the filter will still go in and out ok, and you got anything that broke to keep it from going into the fan, you will be fine, as long as you don't forget to not put the filter back in when your done.
Burning smell and rattle sound
The rubber drive belt is burning up most likely cause by bearing going. The bearings are your ratteling sound and the burning smell is the rubber belt dragging.
Not finding what you are looking for?