Top 20
Gaggia Titanium Espresso Machine Questions & Answers
Coffee machine is on but lcd is clear
Well I guess you know the display is burned out, the question is this do they make parts for the appliance, based on my experience the answer is no.
My machine is stuck. The LCD reads Rinsing Cycle, Close door
IT LOOKS THAT THE COMPUTER IS TELLING YOU TO CLOSE THE DOOR FERST BEHIND THAT DOOR MAY BE A MICRO SWITCH WICH IS NOT DOING WHAT ITS SUPPOSE TO DO
TRY TO OPEN AND CLOSE MAY BE YOU HAVE TO BE ALITTLE HURDER THEN NORMAL AS THE SWICH MAY BE WEAK. TRY THIS FERST
What is the cause of loud sqealing sound when cycling through brewing process.
coffeegeek.com > Discussions > Coffee > Machines
May 17, 2011 - 10 posts - 2 authors
Cycled the power, tried again, same problem...this time I cut the pump process .... The power switch was one of the reasons I like the MCP over the MC in general. .... It's definitely NOT a vibe...those are loud and vibrate like crazy, ..... of the noise you hear is that "honking" sound (the high pitched squeal) that ...
www.pauljenkins.tv/why-i-almost-killed-somebody-when-i-cleaned-my-...
Coffee weak
warm up well before brewing coffee and set the grinder for finer coffee powder
My steamer is not working properly
Take the nozzle off and wash well also there is a small hole pin size at the top clean out with a pin and push the black inside piece inside nozzle out 2/3 MM out it must pop out I use a chop stick it's perfect. I had the same problem perfect now
Why wont it switch on?
Check the 2-pole circuit breaker on the left side. You have to remove the back by removing 2 screws. Use a multimeter, test for continuity over both poles.
My ~8 year old Gaggia Titanium Plus was dead one morning.
I checked the circuit breaker and one of the two poles were bad.
I replaced the C.B. and all was fine :-)
Not finding what you are looking for?