Gaggia Titanium Espresso Machine - Answered Questions & Fixed issues
Screen says brewunit blocked. Brewunit seems clear
Hi
If you remove the brew unit and put everything back with out it the brew unit. Turn th machine on and see if it will cycle? Open the door and look in the back where the brew unit was. There is a cog in the back with teeth. There are 2 large teeth, and they should be at the 10 and 12:00 position roughly. If they are anywhere else you have a broken drive and need to get the gears replaced. If they are in the correct position check the front of the brew unit where the circles are. There are 2 diamonds and they should be pointing at each other. if they are not you need to bring them together with the key tool. Insert it into the center of the circles and turn until they line up, then put back into the machine, and see if it will work. If it still doesn't you have a bad board.
Rinsing cicle is not stoping.Mashine not
If its is only the rinsing cycle at start up you can go into the menu and turn the rinsing cycle off.
If its the rinsing cycle for the descale, it has to run out of water to finish. Then reprime the machine and it will start to heat again.
Coffee machine is on but lcd is clear
Well I guess you know the display is burned out, the question is this do they make parts for the appliance, based on my experience the answer is no.
Why wont it switch on?
Check the 2-pole circuit breaker on the left side. You have to remove the back by removing 2 screws. Use a multimeter, test for continuity over both poles.
My ~8 year old Gaggia Titanium Plus was dead one morning.
I checked the circuit breaker and one of the two poles were bad.
I replaced the C.B. and all was fine :-)
My machine is stuck. The LCD reads Rinsing Cycle, Close door
IT LOOKS THAT THE COMPUTER IS TELLING YOU TO CLOSE THE DOOR FERST BEHIND THAT DOOR MAY BE A MICRO SWITCH WICH IS NOT DOING WHAT ITS SUPPOSE TO DO
TRY TO OPEN AND CLOSE MAY BE YOU HAVE TO BE ALITTLE HURDER THEN NORMAL AS THE SWICH MAY BE WEAK. TRY THIS FERST
Not finding what you are looking for?