20 Most Recent HP Compaq Presario v3000z Notebook - Page 6 Questions & Answers

Hello,

the problem might be from the screen or the screen bulb.

Connect your laptop to an external monitor and see if any display will come up.

If there is a display, then the problem is either from your screen or from the screen board, or screen bulb.

I would advice that you take your laptop to a repairer so that the fault can be rectified.

Good luck.

check it might need UAA driver first.
Regards

hi plz help me 2 install audio driver of hp C783TU

Below is the link to the service and repair manual to use as a reference.....


http://h10032.www1.hp.com/ctg/Manual/c01035667.pdf

Unfortunately there are no perfect cables, and especially in case of a laptop, when you move it around a lot, roll the cable for travel etc. it gets bent a lot, especially in the place where the elastic cable goes into the hard plug or into the charger case. The conductors inside and the inner insulation finally break, giving at first intermittent connection (what you experienced before), and finally short-circuits the cable, resulting in charger damage.

You should be fine just replacing the charger, unless all this wiggling around didn't break the laptop power socket.

When looking for a replacement charger, note the voltage of the original (it should be exactly the same in the new one), the maximum current amperage (this should be same or - better - higher than original), and the size of plug.

Good luck :)

Here is the download link for "Microsoft UAA High Definition Bus Driver"

http://america.giga-byte.com/FileList/Driver/motherboard_driver_audio_realtek_azalia.exe

Install "Microsoft UAA High Definition Bus Driver" first and install the Audio Driver.

Your sound will work fine.

u try with new Ram

The windows Boot.ini files probably corrupt and windows needs to be repaired. The following repair is for the XP operating system but Vista nd Windows 7 is similiar except the they repair themselves.....

Windows Start-up Errors
Step one, you need a Windows Installation CD. If you only have a recovery disk set like the ones from HP or Compaq they will not do what you need done. Under normal circumstances however, you can use a Dell disk because the Operating system is on a stand-alone disk. All retail versions are also acceptable as well as upgrade disks. For a rule of thumb, if the disk has the Microsoft hologram it should work.
While the computer is first starting up and you see the manufacturers splash screen, tap F12 (some computers it’s F9, others it may be another key, you may have to watch and see if the computer lists the key strokes for getting to the boot menu. If you still cannot find it, boot into the BIOS settings and change your boot order there. Save your settings and exit, the computer will now seek the cd rom as its boot source first.
Place your Windows disk in the computer and start it up. When you see the test at the top of the page “Press Any Key To Boot From CD” Just hit the space bar to activate. The next screen you will see will most likely be a Windows setup screen, when you see this press the “R” key to get to the recovery console. It will get there, it may take a little time, patience. Once it loads you will be given a choice of Windows installations, there should only be one, if there are more, always pick number one. It may ask for an administrators password, if you have not set this particular password, then just leave it blank and press enter. The next prompt you see is:
C:\Windows>
You need to type the following:
cd \
hit enter. Pay close attention to the spacing between the characters. There is a space between the character “d” and the “\”
You are now at the ROOT of the drive, this is where basic commands can be given and changed. You should now see the following:
C:\>
Now type the following:
CHKDSK /R
Hit the enter key.
The chkdsk /r command also includes the P command and will also look for lost recoverable information in bad sectors.
There are occasions depending on how corrupt the system is, that this process could take several hours, so be patient with it.
Now, after chkdsk has run type the following:
FIXBOOT
Hit the enter key.
It may prompt you with a warning, that’s ok, just continue. When fixboot has finished, type: EXIT hit enter and windows will reboot. When the system reboots, tap the F8 key during this time and you will see the multi-boot menu come up. Scroll to the title “Last Know Good Configuration” and hit the enter key. If you were having some simple drive errors this should have fixed them.

you bought the program allready? if no then dont do it because is a false positive so first search on the net or directly download it form this site http://www.softpedia.com/progDownload/HijackThis-Download-5034.html instal it scan and after is finish search the program (security tool) and remove it and reboot that's it.
About your question,your credit card should not be accessible for others but that depends on the site you pay how secure is it. 
If you have other question feel free to ask about this.

Nortons sucks. you should try an anti-virus scan with Malwarebytes, then you should install Avast as your resident protection. 

Be sure, when uninstalling Nortons, to use the uninstallation tool found on the nortons site. if you use the regular windows uninstaller, it will not remove all of it, and it will slow your computer down.

No virus checker catches them all, and frankly, Norton 360 is pretty weak. Try running AVG, which is downloadable and free.

plz try by uninstalling the sound driver and uaa bus driver from the the control panel, then you install the sound driver from the motherboard cd.if the problem is not solved plz feel free to post again

hi,

plz downlaod the latest version and try to installl it...
http://consumersupport.lenovo.com/en/DriversDownloads/drivers_show_1373.html

if the problem continues

change it to xp service pack3
and still problem continues it is due to the audio port connection
device not being recognized plz repair it using your warranty.....



thank you for using fixya,rate my answer
vijay

fine..it seems that u r a professional..
however it may not b the problem of the system board..
plz do the following checks..

try to connect to an external vdu/monitor using the laptops vga port..if there's display..check the lcd, inverter circuit & ccfl backlight..

if not post me comments..i'll guide u to next step(s)..

if problem persists contact system admin/vendor....

there is a possibility that the cable is damaged or the phone port is damaged slightly in the data port. I was going to tell you to download drivers but it seems that it was working before so its either 3 things, computer, cable or phone. 92% of the time its the cable, just try another one. Please let me know if this works for you.

Hi there, normally a clicking noise from a laptop is a sign that the hard drive is damaged beyond repair or going bad. if the computer wont boot at all it is probably from what i said above and you need to have it replaced. Data recovery is possible but is costly.

You obviously have one or more Threats on the Drive..
Install a reliable antivirus on your PC (like KASPERESKY)
Scan the drive before opening its contents.

If VIRUS are too many in number or some cannot be deleted.. immidiately format the Drive
:;))

Too dim I think you mean. But vague is okay I guess

http://dictionary.reference.com/browse/vague

Probably the backlight for the LCD has went bad or the high voltage inverter that supplies the voltage to the backlight. You'll be going to a repair shop.

1 check that it is switched on ( a lot of lapstops default to it being off)
2 Check the security settings are the same at both ends.
3 Check that the work group is the same
4 Check that the ips are in the same range

Did you try uninstalling and then reinstalling the yahoo messenger? This might work. Also, install the latest software there is. I would also recommend to try other programs and see if you can see yourself, just to make sure that the problem is with the yahoo messenger and not the camera.