Kyocera Copystar CS-1820 Black and White Copier - Answered Questions & Fixed issues
KM2820 ERRO C3100
scanner home position sensor error. has to do with the bright light and mirror assembly that moves back and forth under the glass. DANGER high voltage present
What is E31000
Scanner related
=Check if the scanner lock(transportation) is on(should be off).
=Clean inside the scanner.Mirrors and lamp.
How can i remove the error code on my copier: call service C7102
By calling the crevice centre in your manual. sometimes the number is on a card attached to the printer. If you call the centre, tell them what copier you have, what the code is and they also will ask how many copies are made. So write that down before you make the call.
The service centre probably will send a mechanic, to repair the error.
Jam03
Read the manual. Usually unplugging for 1 minute and plugging back in will resolve issue. Check paper track to see if there is any debrea clogging the machine.
C6020
my copier kyocera fs-1118 mfp display error code C6020 please help me the solution.
Fax memory full
you need to cancel job in memory that did not send , or try
to turn off the copier and unplug it form outlet ,then plug back in and
turn on ,this may clear the fax memory.
C6400
C6400 Zero-crossing signal problem
• The engine PWB does not detect the
zero-crossing signal for the time
specified below.
At power-on: 3 s
Others: 5 s
Causes: Poor contact in the connector terminals.
Remarks: Check the connection of connectors YC7
on the engine PWB and YC2 on the power
supply PWB, and the continuity across the
connector terminals. Repair or replace if
necessary.
Causes: Defective power supply PWB.
Remarks: Check if the zero-crossing signal is output
from YC2-11 on the power supply PWB. If
not, replace the power supply PWB.
Causes: Defective engine PWB.
Remarks: Replace the engine PWB if C6400 is detected
while YC2-11 on the power supply
PWB outputs the zero-crossing signal.
HOW TO FIX ERROR 6020
Fuser error. Replace the fuser and reset the error. Firmware update is highly recommended.
E 6000
6000 error. Broken fuser heater lamp wire The fuser temperature does not rise after the fuser heater lamp has been turned on
Not finding what you are looking for?