Top 20 Ricoh Aficio 2022 All-In-One Laser Printer Questions & Answers

Does the copier have a printer /scanner sd card installed and a network card installed in the machine as this is the best option to use the machine as a printer

SC565 *Heat lamp consecutive on error - Broken main fuser connection *Heat lamp consecutive on error - Check HR thermistors with SP1-106 001 (ctr) and 002 (ends) *Heat lamp consecutive on error - Heat roller lamp defective *Heat lamp consecutive on error - Power Supply defective

Ricoh Savin Gestetner Lanier error code errors TRIY THIS FIRST. http://www.copy-star.com/component/option,com_contact/task,view/contact_id,1/Itemid,37/lang,el/ THIS NEXT.SEND AN EMAIL WITH ERROR CODE.......

You have to go into service mode 5832-001 and press the execute button then power cycle the copier after the process is done.

if the above solutions failed, ask a technician to clean the thermistors, as toner build up on them and then give you the same code, have also found that power surge or power failure also cuase this code to come up repeatedly

Someone forgot to remove the tone seal of the PCU ID sensor defective TD sensor abnormal Drum does not turn Development roller does not turn Poor connection of the PCU

Code doesn't exist! You're asking for help and can't even get that right!

SC 542 Fusing temperature warm up error.Fusing lamp defective,poor fusing unit connector,thermistor warped or broken,thermostat has tripped,power supply defective.After verify the componenets try reset the error.Enter in service mode:Press the yellow key and press 107 and keep pressed the stop key 3 second.Touch the SP window on screen open the front door and turn OFF the copier.Wait 1 minutes ,close the front door and turn ON the copier.If the error code persist change the upper fuser roller and the thermistors.

Replace the whole toner holder assembly as the auger inside of it goes bad which causes the user to keep pulling out the toner bottle and checking it which in turn brakes the green handle

What did you repair? as the pcu is an assy and cannot be rebuilt

Defective Quenching lamp. call a tech

For this model specifically, the following will get you into service mode. Hit "Clear / Stop" Buttom then "107" then hold down "color print" buttom for some sec then you are in service mode If that doesn't work, you can also use Clear/Stop,1,0,7, Clear/Start. Each key should be pressed and held until you hear a beep

Cannot be done. Have a tech come and replace the NVRAM. It will cost you a lot of labor.....

You cannot. To remedy this you have to replace the NVRAM. Then all the settings for the machine must be re-entered. Not a job for the unexperienced tech or novice. See this all the time and will never understand why people change it.

Pull the fuser out and put it back in or order a new fuser unit. Please fill out my form for additional information http://ryanluke.net/?page_id=37

It is the termistror problem.....the service you had to do is to read my document on servicing & changing of ricoh 1027/1022 termistor which i had posted 3 years ago

it's either your drum or cleaning blade problem.You had to do PCU maintainance service ,if not be prepared thousands or hundreds bang by copier technician

check the lcd screen of the machine if there is an error code like SC 542. with this machine it will always show what is the problem through CODEs.

first is clean the sensors especially the exit sensor, check also the door switches maybe they are not functioning well so the jam will not be reset