Top 20 HEWLETT-PACKARD OfficeJet 6500 All-In-One InkJet Printer Questions & Answers

replace ink cartridges

Download everything you need here

take cartridge out and put back in should reset it. some times the printer will be on a time set, so you have to fool it

it sounds like your collection assembly is full. this is not something you can do anything about. it must be replaced and it will be costly. you are probly better off to replace it

You need to buy genuine cartridges. Take them back to the dealers and demand genuine cartridges that is if you did not force the cartridges into the slots. If you are printing blank sheets then change toner cartridges.

If IT SHOWS the HP LOGO AND NEVER COMPLETE THE INITIALIZATION; it can be FORMATTER BOARD (rplace it), could TRY TO UPDATE THE FIRMWARE AT HP SITE.

You cannot generally reset a serial number for a machine, as that is a prime identifier for the machine that you are using. Can you please clarify the question a little bit? Why do we need to change the serial number?

This page provides some solutions for slow printing for that Officejet Printer. Slow Printing HP Officejet 4500 Desktop All in One Printer G510a HP... I am an HP employee.

Try another cyan toner cartridge. Let me know what happens. Print Quality Troubleshooting Tool for HP Color LaserJet CP4025 CP4525

Flashing Question mark is attention light/ paper tray set wrong or paper jam either in user or under toner or in front right after pickup roller or cover open switch is on making contact or toner switch check roller for wear my not be picking up paper last paper tray gets stuck in left side front check it

I'm assuming you have the correct drivers loaded and correctly configured. Set power switch to off. Unplug it for 1 minute. Plug it back in. Turn it on. If it still won't work, I suggest replacing the power supply. If it still won't work, I suggest you replace it.

Go to this web site:www.feedroller.com

Hello, In many printers the pick up roller is not replaceable. In such cases the printer has to be serviced. May i know the printer model name/ description to assist you better ?

take the cartridge out & run hot water over bottom where the ink comes out wipeing it with a soft tissue until you get a good stream of ink

make sure you have a phone line plugged in correctly (into the in plug) and set the printer / fax to recieve auto. Do not pick up the phone while recieving the fax, If thei does not work, check your setting in the software.

did you hust replace the fuser? make sure it is the model type/ for example a 4200 does not work in a 4250 they fit and look exactly alike,but, are not compatible.

Try a different outlet and different power cord.

Hi This printer should have problems with the fuser unit or the power supply

Hello, Please click

Hello, Please try the below steps..

1. While the printer is ON, remove the ink cartridges.
2. Close the cartridge access door.
3. Un plug the power cord from back of the printer.
4. Wait for 30 seconds.
5. Plug in the power cord to back of the printer. Printer should power ON automatically, else press the ON button to do so.
6. Install the cartridges when prompted.
7. Try printing, it should work.

If issue still persists, then it could be an issue with the printing system and the printer has to be serviced. Contact HP for support.