Sharp AR-275 Copier - Answered Questions & Fixed issues
Call for service: h4-00
H4-00 means thst the copier isn't warming up quickly enough. Try this code to reset it. Press the following buttons in this order: #, interupt, C, interupt, 1, 4 . machine will say sim 14 trouble clear are you sure. Press the OK button. This should reboot the copier. Most likely the machine is in need of a heater lamp in the fuser unit.
7/2/2021 8:06:25 AM •
Sharp AR-275...
•
Answered
on Jul 02, 2021
•
11,573 views
Have error code e7-80 on
Usually E7 errors have to do with the scanner or the optics. You should get a hold of a technician to see what can be done to fix it.
9/7/2018 10:45:22 PM •
Sharp AR-275...
•
Answered
on Sep 07, 2018
•
2,950 views
Sharp error code l4-01
Main motor Lock, check Main Drive , and resistance contributed by all other applicable units
11/4/2014 9:50:10 AM •
Sharp AR-275...
•
Answered
on Nov 04, 2014
•
879 views
Do I need to input code after chenge new toner?
http://files.sharpusa.com/Downloads/ForBusiness/DocumentSystems/MFPsPrinters/Manuals/cop_man_ar235_75.pdf Go to page 82 for instructions, no code is needed to be inputted after changing toner.
5/13/2014 6:04:42 AM •
Sharp AR-275...
•
Answered
on May 13, 2014
•
56 views
Service F1-15
Your finisher lift motor is not functionning well,just check it?
1/7/2014 4:13:18 PM •
Sharp AR-275...
•
Answered
on Jan 07, 2014
•
89 views
Service l6 10
Sharp AR-M207 . Enter these keys one after the other to reset:
- # - * - C - *(pound, star, C, star).
- The screen will go blank and ask you to enter a code
- Enter "14" and press the print button.
- It comes back and asks if you are sure(showing "1" as default). Press enter.
- Machine should then reset
8/28/2013 8:57:45 AM •
Sharp AR-275...
•
Answered
on Aug 28, 2013
•
149 views
I have an error code e7-02
Does the copier make a load noise like a jet engine starting up???? A E7 means the laser polygon mirror motor is not spinning at the correct speed. The only way to clear the code is to replace the whole laser unit or just the polygon motor... If you fell luck.... you can spray a small amount of WD-40 in the bushing of the motor > it is just a band aid... it will come back.... Good Luck
11/9/2011 3:20:21 AM •
Sharp AR-275...
•
Answered
on Nov 09, 2011
•
97 views
Sharp AR275 copier error message
in order press
* Entering the simulation mode
1) #/P key (program) ON → Asterisk (*) key ON → CLEAR key ON →
Asterisk (*) key ON → Ready for input of a main code of simulation
Simply # * C * and the machine will enter simulation mode.
Then enter the number 16, which is U2 code correction, follow what the screen says, Normally just press start and the machine will reset.
U2 codes are software glitches. A U2 40 is a CRUM fault which is a drum or toner chip problem.
Sim 16 almost always clears them.
5/21/2011 2:20:58 AM •
Sharp AR-275...
•
Answered
on May 21, 2011
•
281 views
Not finding what you are looking for?