20 Most Recent Frigidaire FAD704DWD 70 Pint/Day Energy Star Dehumidifier w/ 16.3 Pint Tank Capacity, Up to 194 CFM, 115V, 2 Speeds, Antibacterial Mesh Filter, Auto Shut Off, Effortless Humidity Control, Full Tank Alert, Continuous Drain Option & Portable Design - Page 9 Questions & Answers

the condenser is probably clogged with dust thus restricting the air flow required to cool it down. if it has a filter on the front, take it out and clean it. if it does not, try to remove the front cover and, using a stiff bristled brush and simple green, clean the fins on the condenser then hose it down. if there, then, is no air flow, check the fan. replace if necessary.

Are you running it canstantly? It needs time to defrost occasionally. Also check the fan's working ok.

Try checking for plugged drain ,also check wire connections

Turn the unit OFF & unplug it. Remove the water collection bucket and set aside. At the top of the bucket holder, just behind the louvers you should see a plastic pull tab, which is part of the filter frame. If you have never removed the filter before, there may be a piece of plastic tape on the filter frame. It was put there for shipping. Remove and discard it. Pull straight down on the plastic tab and remove the filter. It can be cleaned by vacuuming it or if it's really dirty, wash it in with warm water and mild dish washing liquid. Rinse thoroughly, shake off access water and allow to completely dry, before reinstalling it. Never operate the unit without the filter in place, as doing so could cause damage to the unit. The filter should be removed and cleaned once every two weeks.

Hope this helped you and thanks for choosing FixYa.

You will need to unclog the internal drain tubing to the hose connection. To accomplish this, do the following:

Using an appropriately sized, 18" long, plastic Zip Tie, carefully insert the tip of Zip Tie into the hose connection hole & tubing. Continue to push it in until you reach a bend in the tubing. You will need to gingerly work the Zip Tie past this bend, until it either bottoms out or you run out of usable Zip Tie. Then slowly pull the Zip Tie back out while rotating (twisting) it. This will breakup any clogs. As you reach the inserted end of the Zip Tie, be prepared, as some water may follow. Reconnect the hose to the unit, plug the unit in and turn the Master ON/OFF Switch to ON. Set the humidity extraction level to 35% or Maximum if you have a manually controlled unit. Allow the unit to run, while you monitor the hose end for water flow. It may take 10 to 15 minutes for it to start flowing. So be patient.

NOTE: If you don't have a Zip Tie, you may use something similar ( i.e.a long pipe cleaner), but NO wire coat hangers.

Hope this helped you to solve the problem and thanks for choosing FixYa.

Hi,
It finally decided to start working for some odd reason... before it was not working...it is supposed to fill the bucket...

heatman101