...output shaft speed. These sensor readings are used to determine the current gear ratio and RPM slip across the torque converter. The PCM uses this information from the sensors to determine if the ...
...output speed sensor - or at least that is what came up when they hooked the computer to it - you see, mine was not shifting gears correctly - I stopped yesterday to put gas in it - when I left gas ...
output shaft speed sensor. The sensor was replaced and the computer was reset with the obd2 code reader, but the engine light came back on and I got the same codes,also car kick the same way, What can
...output shaft of the transmission, 2WD, or transfer case, 4WD, pass through the magnetic field of the sensor. The frequency and amplitude of the AC waveform increase as vehicle speed increases. If the ...
Question about Kia Sedona
Output Shaft Speed Sensor located on a 2004 Mercury Sable Duratec 24-Valve DOHC The transmission is an AX4N, with a 19 bolt pan. The Motorcraft Part is DY-1210. When cold the car sometimes shifts hard
...speed. well in my case it did have something to do with the transmission. the transmission has 2 sensors mine was the input sensor. it cost close to 150. at the dealer. check to see if that is it. by ...
...shaft connects directly to the transmission differential by passing through the PTU. The PTU then drives the driveshaft at all times. The driveshaft drives one half of the rear axle clutch pack. The ...
1,649 questions posted
Usually answered in minutes!
1,065 Questions
969 Questions
705 Questions
468 Questions
212 Questions