1998 Chevrolet C/K 3500 "chevy truck ignition module" Questions

...chevy pickup ...It will crank but will not fire. get a spark tester,if there is spark then there is a fuel problem.put fuel spray into the throttle body and see if it starts and dies out. then it is ...

Cant find the ignition control module for Chevy 3500 Dually The gas engines should have the module and coil mounted on the intake close to the distributor.

Chevy 2T trck w/electronic ignition conv Not getting spark. Need wiring diagram for 1970 2Ton truck with electronic ignition conversion. Make sure you give it a good tune up. Make sure that your rotor

...chevy van not getting spark.was running fine day before.turns over fine,getting fuel.could it be the module First thing is what condition are the distributor cap, ignition rotor, and spark plug wires ...

98 chevy 3500 7.4 l no spark Changed the ignition module, plugs, wires. Is not a fuel problem. It does not get spark. check crank sensor

...Chevy 3500 4x4 454. Will crank but will not start. Fuel pump is working and have fire to all plugs Have a 98 would crank and run for a second.the problem was security.the ignition switch housing and ...

Chevy 1 ton 4x4 with a 454 motor in it. I was driving it one day and it just stalled, it wont start back up, it has gas in it. Any ideas on what it may be? It is likely the electronic ignition control

...chevy diesel 1 ton 4wd pickup truck? Ignition Switch Removal & Installation To Remove: Remove the steering column trim covers. Remove the wire harness from the retainers as needed. Slide the 2 ...

...Chevy Corsica keeps stalling while driving Had a tune-up, replaced ignition module and ignition coil. While driving the car lurches forward without giving it any gas or completely stalls. When ...

...chevy sport van and it runs for a little while and then just dies we had a new fuel pump put on along with the new hoses but could this be a bad ECM causing the van to just stop running? I would not ...