2003 Ford Mustang "cam turned" Questions

...both cam sensors had check eng light turned off and light came back on and code comes back as cam sensors check the wireing to the sensors< also there is a special too to set the cam sensors ...

...cam sensor. The pump should run for 3-6 seconds when the key is first turned to the "on" position and then when the ECU registers pulse from the cam sensor it sends the signal to the relay to run the ...

If both cam/crank position sensors have ONLY been unbolted and replaced with new sensors, do they require synchronization? Error code P1336. Cam or crankshaft HAS NOT been replaced. Only sensors. ...

I put new valves,cam,lifters and rocker arms. on my 1966 'A' code mustang 289 and now it hesitates and acts as though it is starving for feul do you have any suggestions all of the parts are ...

...make for large changes in oil pressure. did they install new cam bearings if so a cam bearing turned wrong could cause problem what pump did you install the best pump is high volume not high ...

mustang 2009 turn signal won't turn off the multifunction switch that you use for the signal may be broken on the inside our the cam inside the steering wheel has broken

...timing marks should have been marked up before pulling the engine down. check for 'notches' in the cam and crank pulleys with matching notches on the surrounding cases. be sure not to bend valves. ...

...going from key switch to ingnition switch ,it is probly not in the slot any more or the ingnition cam is ...

2005 ford mustang v6 just rebuilt engine after throwing cam chain and destroying right bank,every thing replaced,started but ran a bit lumpy. For 30mins. check engine light came on but no codes came ...

...turning over but not starting unlikely to be a fuel pump run the fault codes and look for crank/cam position senor problems , ignition control module problems, ignition switch ...