...system. Each coil mounts on top of the spark plug and is bolted down to the intake manifold with a 8mm bolt. You'll need to unplug the electrical connector to the coil, remove the 8mm bolt and pull ...
Question about Ford Crown Victoria
...inches long. It sits on top of a steel bracket. There are three 8mm screws holding it on to the steel bracket. Once you take those off, there is a plastic clip towards the back. Release the clip and ...
...see it. it's bolted to the body with 2 8mm bolts. that is you have to use 8mm socket. It's black and about two inches square. It's a little hard to see but it is there. hope this helps leave
...on my 1997 buick lesabre 10mm or 3/8 inch The battery cable requires a 5/16 inch socket, or an 8mm socket. The hold down bolt should be a 10mm socket on a long
how many inches is 8mm? 5/16 of an inch.
...need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet. find the coil packs (6 total, three in each ...
...see it. it's bolted to the body with 2 8mm bolts. that is you have to use 8mm socket. It's black and about two inches square. It's a little hard to see but it is there. hope this helps leave
...socket for the coil packs where underneath them is a deep hole and down there is the plugs---8mm socket for the fuel rail bolts(for the left side sitting in it)which i would use 1/4 inch drive ...
Question about Ford Crown Victoria
...belt, after you break loose the pulley bolts 10mm then move belt off to side continue removing pulley then you will se water pump 8mm bolts the diameter of pump is roughly5 inches and is
...THAT =204 SEEMS TO BE TO MUCH IN INCH POUNDS AND I DONT WANT TO STRIP THE BOLTS They are probably 8mm bolts and 17- 20 seems to be where they would ...
453 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
294 Questions
301 Questions