1999 Oldsmobile Alero "metric bolt torque" Questions

...METRIC SOCKET FOR AXLE NUT.USE 6 POINT SOCKET.DONT USE 12 POINT SOCKET.COULD DAMAGE AXLE BOLT EDGES.MAKING IT HARD TO GET OFF.YOU NEED A TORQUE WRENCH WITH THE RANGE OF 200 FT LBS TORQUE.YOU NEED 1/2 ...

...TORQUE ON ABOUT 200 FT LBS.USING A SIX POINT AXLE SOCKET SOCKET SIZE COULD BE 34 OR 35 METRIC 1/2 INCH SOCKET.YOU NEED 1/2 INCH BREAKER BAR.ONCE YOU LOOSEN AXLE NUT A LITTLE THEN RAISE VECHICLE THEN ...

...BOLT SIZE METRIC 13M TORQUE IS - 39 - 41 FT LBS IF BOLT SIZE IS 15M METRIC TORQUE IS 51 - 55 FT LBS 17M METRIC BOLT TORQUE IS 83 - 95 FT LBS 19 METRIC BOLT TORQUE IS 105 - 115 FT LBS. CHECK THESE ...

...metric measurement equal to the standard measurement. You interpret the torque settings like this 184 ft lbs OR 250 Newton Meters. The three hub bolts should be tightened to, I believe, 80 ft lbs OR ...

...BOLT UNTIL TENSION GAUGE READS 120 LBS USED BELT NEW BELT 180 - 200 LBS. YOU NEED ALL BASIC MECHANIC TOOL SET WITH METRIC SOCKETS METRIC OPEN BOX END WRENCHES.SIZE WRENCH RANGE 5MM UP TO 19MM NEED ...

...bolt or nut. Partially remove the bolts so that you can measure the shaft and obtain the correct torque from the chart. See ...

...of lines on the head of the bolt.....3 lines grade 5....6 lines grade 8....metric bolts will have a # decimal point and #......You may can google it...otherwise consult Machinist Hand

bolt is in metric or small in diameter that translate into metric 13.558 newton meters per1.5875 mm This rule of thumb does not account for how many times the item has been reused or it's condition so

...bolt torque specs? my torque wench has 1 side is newton mters and other side is foot lbs so which setting should is use? cylinder head bolts to 25 Nm (18 ft. Lbs.) And turn the bolts another 3 turns ...

bolt tension for 2010 Mitsubishi FN64F 6M60-3AT2 The term you mean is actually torque. Cylinder head torque is usually specified in foot pounds, or in the metric world, newton meters. It describes how