2000 Mitsubishi Galant "measure transmission oil level" Questions

...oil The transmission fluid goes in the same tube that holds the dip stick that you check the fluid levels with. You will need a funnel, and be sure to use only manufacturer recommended fluid in your ...

...measure oil level this way....as well as the transmission. The Dip Stick tube is only for sucking out the oil. This is known as 'Top Side Evacuation'. Some DIY types collect and measure the drained ...

measure oil level, and the other transmission fluid level( typically labled 'check with engine running in park'). To add transmission fluid requires a funnel to introduce fluid via the dip-stick tube.

how i check the level of oil transmission of then isuzu rodeo 99 It has a stopper on one side of the transmission that is where you measure the oil level and gets the oil there. Thanks

...measure the lubricating oil level. Remove the transmission filler plug and check oil level. Remove differential oil filler plug and check oil level .Check fluid level .check coolant level.Observe all ...

...Measure the pan-to-transmission housing clearance using a feeler gage and a straight edge. Use a feeler gage to check the clearance between the oil pan-to-transmission housing measurement points If ...

measure Transmission fluid after letting the car warm up. It measured very high Two things: #1 someone has overfilled it by mistake thinking they were putting oil in the engine. Yes I have seen this.

...TRANSMISSION, SO I CAN PROPERLY CHECK THE FLUID LEVEL WITHOUT PAYING? WHERE IS A GOOD PLACE TO GET THE DIPSTICK TOOL NEEDED? code readers cant.the scan tools can but are real expensive.if you havent ...

...transmission are filled with oil. 3.Step on the brake firmly, apply parking brake fully and move the selector lever through each gear position, pausing briefly in each gear. 5.Reinsert dipstick ...

...transmission oil level? you measure the trans level by pulling the trans dipstick with the car warmed up (after a short drive), on level ground, engine running-it should read within the 'hash marks' ...