...Blend Air) doors. A malfunctioning Blend Air Door actuator probably caused it to break. The dash will have to be removed to replacethe door and the door actuator. YOU EITHER HAVE A PROBLEM WITH THE ...
air blend door jeep liberty 2010 no heat My blend air door is stuck on my 2010 liberty. I have removed the actuator panel on the drivers side and the middle door that controls the air flow to the dash
...air conditioner only seems to be working/blowing through the bottom vents, and not the main vents. Usually a sign of a stuck blend door under the dash. Could be a faulty blend door actuator, or the ...
Question about Jeep Liberty
...it back and forth no change in air. bottom one seems to change air temp when u turn it. does this mean blend door is broke and how do I get at it ? The door is defective the shaft end is sheared
...air in heat mode Sounds like the heater control valve/ blend door. The actuator may be stuck or broken. The actuator opens and closes to adjust for the heat setting in the car. You might be able to ...
Question about Jeep Liberty
...air on floor, by-leavel and defrost heat setings Blend door actuators could be bad, or vacuum leak in hoses. guess again? for sure dampers are not right only why remains. recirc door is vacuum. servo ...
...air inlet door, mode door or blend door . This seems to be a common problem. Further inspection will be needed to verify which actuator and door is the problem. There is a Technical Service Bulletin ...
...air? Blend door is not moving to open to the heater core. Coud be that the cable is not connected to the dash lever but if it's vacuum actuated the vacuum line could be off. Check that your getting ...
...blend door actuator is not functioning properly, or if the temperature of the conditioned air is too warm with the temperature control in the full cold position or too cool with the temperature ...
Question about Jeep Liberty
air passing thru the heater core. The blend door is usually moved open/shut by an actuator. Sometimes this actuator goes bad. In less common cases, the water pump impeller/bearings may be bad, and not
381 questions posted
Usually answered in minutes!
1,658 Questions
839 Questions
768 Questions
735 Questions
633 Questions