Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "high low settings carb" Questions

...high/low i need the high/low settings for the carb. older 33cc with 16" blade Homelite 33cc 16inch Hi, most chainsaws start with carb settings at 1&1/4 turns out( hi+lo) usually once the ...

...low and high settings on the carb With all the new EPA guidlines on emissions there are many new type of carbs.The older type was easy, If its a walbro or zama brand and it has 2 adjustment screws as ...

...high and low needles on carb polen 42 18" thanks The standard setting on needles is to screw them in all the way and then back them out 1 and a half turns. You need to set the mixtures for the ...

LOW and HIGH speed screw settings what are the LOW and HIGH speed screw settings for a Ryobi RCS4040 Chainsaw you those to adjust the carb hi is balls out running , sometimes it sounds sick or ...

...high and low running start saw set low speed first adjust screw in or out to get best low running then rev saw to max.and adjust max revs do the same as you did with the low speed screw to obtain max ...

high and low speed carburetor jet settings set the air gap at .011 to .012.inches,set carb high and low needles at 1 turn and 1 turne to start. after running it might take a minor adjustment to finish

high and low adjustment screws;however the cover over the carb. seems to have an effect before and after adjustments are made to the general performance of the way she runs once warmed up. my question

...low speed adjusting screw all the way in then turn it out about 1 1/4 turns out. repeat with high speed screw. when running readjust low speed until proper idle and high speed for proper high rpm

...low and high.The low is for when the saw is in low at speed or when is not in use for cut.When you pull the handle to start cut then the adjust the high one at max speed. If you need more help come ...

...high & low for husqvarna 181 se so started with 1/4 turn. The plug is wet and will not start but did fire just fine until fuel made it thru the carb after working on it. The low was set at 1-1/2 ...