Husqvarna Craftsman 36cc, 16 In. Gas Chain Saw "chainsaws dies high" Questions

...on a walbro carberator wa19 on the needle on a poulan chainsaw xxv? The chain dies out when it is under cut or high rpms Initial setting is one full turn on low and high side. Fine tune from

...dies when throttle applied. what can I DO I've got the same plroblem, let me know if you get advice from the expert. Engine should be warmed up somewhat--try turning the high-speed-mixture-adjustment ...

...has a choke pulled out all the way to start it then runs/revs to high. when he pushes the choke in it dies. what needs to be fixed inside? check ur governor spring or linkage---adjust air/ fuel ...

...dies out;cleaned out carb. relaced fuel lines . give it gas wont throttle up.adjusted high and low speed screws no luck. replaced fuel lines and filters.sounds like its getting air no fuel and starts ...

...high revs, floods, and dies when i let off the choke its been standing all summer ,,,yes? you have a carb fault strip the carb and fit a new repair kit in it, also clean out all the carb jets,,plus ...

...high enough to properly start moving the chain, there is no sign of movement by the chain whatsoever. Then it starts to smoke and run poorly and then die. Starts then.... you hit the trigger... ba ba ...

...dies. I think the high and low settings are way off. I also would like two know the factory settings for this model. Have any ideas? Start with a new sparkplug, then check the gasket on the carb. The ...

...(maybe idles) but then dies when giving it gas it sure looks like its a carb problem , most likely dirt in the high speed jet , but could be a dirty fuel filter as well and that's inside the fuel ...

...high idle on the choke it runs for about 3 seconds and then dies like it ran out of gas When it dies pull out the spark plug. If it is dry it is getting not enough fuel,wet is too much .Adjust the L ...

...high speed for a few seconds but dies under load. Sometimes cuts half a limb before it dies. Changed gas and then changed spark plug. Still dies. have you looked at the filter in the tank? get a wire ...