SOURCE: how do I take out the ash tray
pull out the ashtray and on top is a metal tab that stops it from coming all the way out. Push down on that metal tab while you pull out on the ashtray. Good luck and be safe.
SOURCE: replace bulb
Hi,
I had an 86 Ram. Most of the lighting was behind the dash bezel.
This is an illustration of a 98 ram dash wiring diagram.http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?chapterTitle=Instruments+And+Switches&partName=Chassis+Electrical&pageId=0900c152800c0a34&subChapterTitle=Gauges+%26amp%3B+Bulbs&partId=0900c152800c09ae
If this helps, please rate me. Thanks,
Matt
SOURCE: i dropped a ring down between ash tray of front
If you can see it, and if the ring fit, so will a fish wire. Go Fish!! Just kidding. How much is the ring worth? Alright, I'll quit. Is the console tight against the carpet on its sides? There shouldn't be but a few screws holding the console to the floor. Locate them and remove them. Then see if you can lift the console enough to have the ring fall out. Hopefully it went aganst one of the sides. If it doesn't come running out, get a buuter knife or fingernail file and kinda move it around. If that doesn't scare the critter out, Look into the hole or shift slot and try to locate it. If you see it,Get a straight section of coat hanger and nudge it to one side or the other. Do not tug or put pressure on anything becaus of wiring. You can get it out, it just takes patience. Good Luck. Let me know if you are bringing it to me to do the patient part. Seriously, let me know if you get it. _Ned_
SOURCE: 2006 Cadillac STS - How do i remove the plastic
it is all clips and a couple of hidden screws torx bit # 15
SOURCE: Replace light bulb under dash that shines on console and ash tray
remove the ash tray,then remove the screws that hold
the ash tray bracket in place the bulb will be very easy to change then.
30 views
Usually answered in minutes!
×