20 Most Recent 1998 Ford Taurus Questions & Answers


I would check fuel pressure before and after you crank the engine.
The pump gets power for 3 seconds during startup - if the fuel pressure has leaked down you would have to crank the engine until the oil pressure came up to get the pump to power up again.

1998 Ford Taurus | Answered on Sep 30, 2018


Hello Melita.

The fuel pressure for the Taurus;

Engine Running 240-310 kPa (35-45 psi)
Key ON Engine OFF 255-310 kPa (37-45 psi)
There you are as asked, thank you for using FixYa.

KL

1998 Ford Taurus | Answered on Sep 30, 2018


you should not have to sypon the fuel just locate the fuse that controls the fuel pump pull it out and start the car when it stops there will be no pressure in any line. you should be able to remove the fuel pump without any trouble then

1998 Ford Taurus | Answered on Sep 30, 2018


No that is it, More then likely your 02 sensor needs to be replaced.
But other possible causes would be excessive fuel pressure, leaking/contaminated fuel injectors, leaking pressure regulator, low fuel pressure or running out of fuel, vapor recovery system.
Other possible causes could be: Air leaks after the MAF, vacuum leaks.
Possible causes PVC system:
improperly seated engine oil dip-stick.
Possible causes EGR system:
Leaking gasket, stuck EGR valve, leaking diaphragm or EVR.
Possible causes Base engine:
Oil over filled, cam timing, cylinder compression, exhaust leaks before or near H02S(s).
I know its a lot of info but it could be anything. Take your time, good luck. Let me know how it is going.

1998 Ford Taurus | Answered on Sep 30, 2018


Hi Nancycardno,
The spark plug #6 is located on the cylinder head that is closest to the radiator and it is the one closest to the driver-side.Hope this helps,if you need anything else,let me know. Thanks,Chuck

1998 Ford Taurus | Answered on Sep 30, 2018


maybe your plug going to the spark plug is bad or the distributor cap

1998 Ford Taurus | Answered on Sep 30, 2018


if its a 3.0 with vin# 1,2 or u the firing order is 1-4-2-5-3-6

if its a 3.4 with vin# n the firing order is 1-5-4-2-6-3-7-8

hope this helps, good luck!

1998 Ford Taurus | Answered on Sep 30, 2018


Find the passtime device , it's usually under the dash near the ignition switch. You can trace it by following the wire from the remote eye. There are 5 wires with a plug connector plugged into the device. Leave the red, pink and black wires alone. The blue wire comes from your ignition switch and goes to a relay switch inside the device. The purple wire comes from that switch to your starter.
Leave them cut from the device, but solder, (or connect in some manner) them together so that the passtime device is bypassed. Then your starter will get power when you turn the key. That's all there is to it.
the passtime device will still appear to be functioning. It will beep and take codes from the remote, but regardless of whether it is timed out or not your starter will still get power.

1998 Ford Taurus | Answered on Mar 05, 2018


Testing before replacing parts should be done ,an if you don't know how , take it to a qualified repair shop. What made you pick on the TCC solenoid ? That would have nothing to do with it at idle . I would look at scan tool data for the IAC - idle air control valve . Clean the IAC passages , throttle plate ect....

How To Fix Car That Idles Poorly

Idle Air Control Valve

1998 Ford Taurus | Answered on Feb 28, 2018


possible splines stripped in torque converter that turns transmission pump. Our 2006 ford minivan did this to me when I stopped to get gas. it would not move when i started back up. I cannot remember if scanner showed transmission pressure or if I had to hook a gauge up to find out. I basically had to replace torque converter, I did flush transmission cooler in case medal from stripped splines was circulated thru system.

1998 Ford Taurus | Answered on Feb 11, 2018


Wendy,

Have you checked your transmission fluid level? Make sure car is level, engine running with engine and transmission at operating temperature. The dipstick is located under hood, on driver side behind engine. Typically has a yellow handle.

Check that and report back.


helpful-fbhtsuujths3pkuos2jmb534-2-0_2.png

1998 Ford Taurus | Answered on Feb 09, 2018


you have got a air leak by what you say retrace your work especially the manifold gasket

1998 Ford Taurus | Answered on Jan 31, 2018


Hello Anonymous
...
The ANSWER f/JIMMY really is quite excellent... Many serious
Old time "MECHANICS" really do use various tools & sticks
As listening devices... Problem is... They are inherently UNSAFE...
If you accidentally stick that long EXENSION into your FAN... it
May end up sticking out of that OTHER EAR...!!
PROPER-TOOL: Mechanic's Stethoscope (safe & inexpensive

https://www.amazon.com/Lisle-52500-Mechanics-Stethoscope/dp/B0002SQYSM/ref=sr_1_2?ie=UTF8&qid=1514611189&sr=8-2&keywords=lisle+stethoscope

I'm just saying...

En.wikipedia.org/wiki/carnac_the_magnificent

Amazon com Lisle 52500 Mechanic Stethoscope Automotive

Amazon com Lisle 52500 Mechanic Stethoscope Automotive Carnac the Magnificent

1998 Ford Taurus | Answered on Dec 30, 2017


Check the pully on your a/c unit. Mine on my 2003 ford f250 siezed up and locked the engine up. Prior to that my harmonic balancer pully failed.

Steve

1998 Ford Taurus | Answered on Dec 22, 2017


sound like it could low fuel presser. or clogged fuel filer. so start by changing filter then check fuel presser.

1998 Ford Taurus | Answered on Dec 19, 2017


It will not pass inspections. The purge valve could be a vacuum hose cracked or something simple but it could also be a worn out valve. The pcm failure could be very expensive.

1998 Ford Taurus | Answered on Dec 11, 2017


you are just wasting your time and money and getting no result i suggest you to get the service and repair manual and fix the problem without the help of the mechanic so go to the the given link and get the manual http://toolsnyou.com/

1998 Ford Taurus | Answered on Dec 11, 2017


Check all cables including those to alternator for corrosion, typically greenish. Dielectric grease is helpful on contacts. New cables may not be necessary but if heavily corroded they aren't terribly expensive.

1998 Ford Taurus | Answered on Oct 30, 2017


maybe pixels gone bad check that.

1998 Ford Taurus | Answered on Oct 07, 2017

Not finding what you are looking for?
1998 Ford Taurus Logo

1,977 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Taurus
1999 Ford Taurus

2,314 Questions

2001 Ford Taurus
2001 Ford Taurus

2,217 Questions

2000 Ford Taurus
2000 Ford Taurus

2,061 Questions

2002 Ford Taurus
2002 Ford Taurus

1,832 Questions

1996 Ford Taurus
1996 Ford Taurus

1,342 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Taurus Ford

  • Taurus Ford

Most Popular Question

turning off door chime when key in

  • Cars & Trucks
Loading...