The cruise control switches are located on the steering wheel. When the cruise control is turned on there will be a green light luminated on the dash that says "cruise". When at the desired speed press "set" to set the cruise control at that speed.
SOURCE: 93 jeep grand cherokee, cruise control
Just in case you haven't got this fixed already, I just noticed on my 93, the cable from the vacuum control, (the cone shaped device on the passenger side near the coolant overflow ) was sitting against the tubes from the ac compressor, it had started to melt from me using the ac, if it melts through I am not sure if it would cause a vac leak, but if it did, you would only be able to detect it with the cruise on, not easy to check with the vehicle parked. I used a couple of cable ties to secure it away from the tube..not sure if you can tape around it to fix if it has melted.
just thought I would throw it into the mix.
j
SOURCE: 2003 jeep grand cherokee cruise control not working.
it must be the part on the transmisiont that either went bad or the connections are bad
SOURCE: cruise control not working
Review this information about Jeep-WJ-Cherokee-Service-Manual-PDF-08W-Diagrama-de-Cableado (Wiring Diagrams / Section 8W Page 181 (8W 33-1)
Is in spanish, but the graphics can help you.
Good luck!!!
SOURCE: cruise control no go when button is pushed
I press the control switch on my 1999 Jeep cherokee. the cruise light doesn't come on and the cruise does not engage. Please offer a solution.
SOURCE: 2004 jeep grand cherokee cruise control does no
try the brake switch located behind the brake pedal....had similar problem and this fixed it
1,061 views
Usually answered in minutes!
×