At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Re: We are looking for a wiring problem with the fule...
There will be a fuel pump relay , and maybe even a fuse.
I am not sure where on your F250 , but most likley in a fuse/relay panel in the engine compartment.
Exact location should be easy to find on line.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
look under rear seats or in boot floor for round inspection cover. remove screws lift cover off and disconnect wiring and fuel pipes then remove unit from top of fuel tank. fuel pump should be located at bottom of unit. MUCH EASIER WITH NEARLY EMPTY TANK OF FUEL
You usualy drop tank to get fule pump but on this car you may be able to get to it if you remove the rear seats. by doin this you expose the top of the fule tanks(right where the fule pump sits)
first you need to relive the fule system of pressure. do this by finding your fule pump relay disconecting it and start the car. it will sputer, this is reliveing fule pressure.once it stops sputering your ready to get the fule pump out. it is located in the fule tank. the tank is held on by 2 straps your going to have to take off. once you do that drop the tank and the pump will be on top of it.
sounds like the vent is blocked, this is located near fuel tank, lots of times spiders make a nest in the hose which blocks the venting here a diagram to help you locate the vent hose.which i new what year and engine was in it but most evap systems are set up very close, hope this is helpful.
The fuel pump is located in the fuel tank and is accessible once the rear seat cushion is removed and, the filter is located Under vehicle, driver side, below seating area,
driver side of fuel tank, mounted on frame in fuel
line.
it is located in side ur fule pump and ur going to have to draing ur tank and take down ur fule tank down and disasemble the gas pump also try ur fule filter
hi ted , the grey wire at the fuel pump goes to the fuel pump relay , and the relay gets its power from the ECM B fuse 20 amps , located in the underhood fuse relay center , when you tested for power , how did you do the test ? a test light at the grey wire while someone was cranking the motor ? i'm looking for a fix ya vote , so if finding your fuse doesn't solve your problem comment back before voting and i will help you , thanks .
The fuel system before the fuel pump should be checked to verify that there is no clogging of fue lines. There might be a possibility that the fuel tank could have corroded deposits, so when the fuel pump sucks fuel from the tank, these debris are collected into the fuel system which can cause blockages, so in reality the pump itself mite not be the problem. Also is there anyway that you can verify that the fuel pressure is of desired value (psi)?
×