SOURCE: 2004 chrysler pt cruiser starter motor removal
You may sneak it out with small fingers with out pulling out the starter.
If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.
Please rate this a fixya
SOURCE: coolant
Read the under hood specs. this coolant can be purchased at the dealer. But, it is orange in color. Not your regular coolant and it is a little more exspensive. Change your thermestat while you are at it.........runjoe
SOURCE: 06 pt crusier wont start
fuel pump has`a`cut-off switch that needs to be reset. Two most common locations are in the trunk on the sides, or on the passenger side kickplate under the glovebox on the right side of the inside passengers right foot.
SOURCE: PT Cruiser Timing chain and water pump problems removing
It's a pain to get out I just did mine belt and water pump it took about 3 times as long as I thought.
Make sure all the bolts are loose, make sure you have removed the tranmission mount as it gives you more room to move the engine. It's suggest you take the exhaust off as well as you can damage it if you jack the engine up too high. Lossen the bolts on the motor mount across from that plate, you will not be able to remove the motor mount but you can spin it allowing you to get that big plate out.
PM dhirst on ptcrew.com if you want some pics or more instructions.
SOURCE: headlight adjustment
If you look at the front of the headlight, there are actually a couple of screws around the edge. These are your adjustment screws.
263 views
Usually answered in minutes!
×