Where is the fuse for the ride control on a 1992 e

The cruise control fuse is a 15 amp fuse located at position #17 in the fuse block. That's the only fuse I see in that circuit according to My wiring diagram. I hope this helps. Take care.

Service Ride Control - Air Ride fuses to check first - YouTube

? 2:55
www.youtube.com/watch?v=p2oao_8GjNM
Jan 31, 2013 - Uploaded by D Cloes Service Ride Control - Air Ride fuses to check first. D Cloes ....+Bruno Lopez You don't reset it like say a "check engine" light. It goes off by itself ...

When this occurs you have an problem with your ride control.You need to replace your front struts on your car.Also it can be that your vehicle may have an problem with your air shocks located in the rear of the vehicle.Sometimes,these vehicles are prone to have an slow leak out of the rear air shocks that as an result cause the service ride control warning to accumulate.

Hi,
Here is a detailed solution on how to reset your 1992 camry;
1.Open the fuse panel cover in the driver's side footwell by pulling down on the fuse panel cover.
2.Locate the fuse for the electronic control unit, or ECU.
3.Pull the ECU fuse using the fuse pullers in the fuse panel.
4.Turn the ignition to the "On" position and wait five minutes. Then reinsert the fuse. The check engine light will blink several times before going out.
This will reset the computer on your 1992 Camry

Thanks..

You replaced the blower control module or the blower control panel on the dash? This has automatic temp control right?

CHECK THE REAR SENSORS AND WIRE.
THEY MAY HAVE BEAN PULLED APART OR RUST IS FOULING THE SENSOR PICKUP.

Could be a fuse, a relay, the switch for ride height, bad accumulator or lack of fluid. Go to benzworld.org or peachparts.com for more specific help.

Are you sure your truck is a) 1992 and b) a Sonoma. ?
The 1994 Sonoma CC fuse is the same as the Brake fuse. See below:

I cant find my fuel pump fuse? on a 1992 Buick Century

do they have any pipes or wires running to the shockers??