89 chev s10 how to replace front axles - 1988 Chevrolet S-10

89 chev s10 how to replace front axles - next.gif="/uploads/images/next.gif" alt="next.gif" class="h_mi" /> Halfshafts (Drive Axle) REMOVAL & INSTALLATION Fig. 1: A torn CV-boot requires remo89 chev s10 how to replace front axles - 85387081.jpgriveshaft for overhaul
Fig. 2: O89 chev s10 how to replace front axles - 85387082.jpgles. the caliper should be removed and supported out of the way
Fig. 4: Once the lower shock fasteners 89 chev s10 how to replace front axles - 85387085.jpgit may be compressed and wired up out of the way
Fig. 689 chev s10 how to replace front axles - 85387087.jpg cotter pin and retainer so the axle nut may be loosened Fig. 7: A prybar may be used across to of the lug nuts in order to keep the hub from turning while loosening the nut
Fig. 8: Use a suitable axle shaft removal tool to drive the shaft from the hub
Fig. 9: If a driver tool is not available, thread the nut just flush with the shaft end and tab gently with a rubber or brass mallet
Fig. 10: During assembly, hold the hub from turning and torque the axle nut to specification
FRONT DRIVE AXLE Identification The front axle assembly used on most 4wd models covered by this manual utilizes a central disconnect type front axle/transfer case system which allows shifting in and out of 4wd when the vehicle is moving under most driving conditions. The axle has an aluminum carrier which includes a vacuum activated center lock feature. The axle on the MFI-Turbo is designed for full-time four wheel drive and therefore is not equipped with a disengagement feature. With this one exception, the MFI-Turbo and standard 4wd front axle assemblies are very similar. The drive axles employ completely flexible assemblies which consist of inner and ou89 chev s10 how to replace front axles - prev.giftant velocity (CV) joints connected by an axle shaft. The inner CV joint is a "tri-pot'' design, which 89 chev s10 how to replace front axles - next.gifetely flexible and can move in and out. The outer CV joint is a "Rzeppa'' design which is also flexible but cannot move in or out. NOTE: For more information on front axle identification, please refer to Section 1 of this manual.