Hello! Here is a picture of the location of the front knock sensor for a 3.8 liter V6 3800 Series II (97-03)
(Please note that the engine is upside down on the stand)
There are 2 knock sensors on this engine, one on the front (as shown), and another in the rear. There isn't one on the driver's side, per se.
I recommend that you let the vehicle cool down before beginning this process. To remove this you will need a drip pan, as coolant will leak from the engine when the sensor is removed. You will need a deep well 22mm socket and torque wrench.
1. Jack up and support the vehicle on jack stands so that you can work from underneath the vehicle. Be sure to apply your emergency brake.
2. Identify the knock sensor location and remove the electrical connector on the bottom.
3. Using the deep well socket, remove the sensor from the block. Do not position yourself direcly underneath this, as coolant will begin to flow immediately from the sensor's location.
4. Your new knock sensor should come pre-coated with sealant/threadlock, just install it and tighten by hand until snug.
5.
Torque the sensor to 14 ft lbs.
6. Replace the electrical connector.
7. You should flush the entire coolant system to be sure to remove any air pockets, and then refill.
Hope this helps and thanks for using FixYa!
Try looking on the side of the block that is towards the front of the car, up high towards the exhaust manifold. near to the center of the engine.
×