I PUT THE CAR INTO GEAR AND THERE IS NO RESPONSE. IT HAS FLUID ,LINKAGE IS CONECTED? It was driving just fine stop. got in started it up drove 10 feet and lost the pull of the transmission. there are no noises, have no leaks. the car only has 50,000 mi.

Are you sure it's not just the linkage jammed up with sand? If it is internal, drop the pan and you should be able to see if a solenoid has broken, as they usually come loose from the base. Good time to change filter and fluid too.

did you check fluid level if low could have burnt up transmission-check fluid level also check color if brownish and smells burnt fluid either was low or overheated and possible filter problem---internal failure with a gear----selector cable damaged or disconnected

might be that you accidentally disconnected the crank sensor close to the transmission, this gives a no start condition without a check engine light on most cars...

try adjusting your linkage

You very likely have a failed transmission here. You need to have a local transmission repair shop drive it and confirm my guess is correct.

Take it back to where you got it and make them refund your purchase price. If they refuse and you finianced it go to them, There a law called "The Lemon Law" that makes it unlawful to sell something like that. Sounds like you sure bought one. Don't do anything to it just get hold of the place where you bought it and tell them to come get their junk out of your yard! dhgill1949

My guess is the clutch is not releasing completely. I would syart by checking the fluid level in the clutch master cylinder.

When you put the car in gear, do you feel it trying to move in any gear? usually if one gear goes you still have the others. I would make sure the shifter linkage is hooked up and in the right position. Not saying the trans could be bad but it's a lot cheaper to check the other (possibilities) before the trans. and torque convertor. I would even try changing the fluid and filter.

only two options you have are check fluid and get it to a shop for inspection