I have a 2008 pt cruiser. The engine light is on

Question edited for clarity.
Question moved to sub category.

Where the fuel pump reset button or the engine rest - RepairPal

https://repairpal.com > where-the-fuel-pump-reset-butto...
Jul 13, 2020 - Is there reset button? Plug diagnostic its says no problem ... Where the fuel pump reset button or the engine rest. 2008 Chrysler PT Cruiser.
1 answer · Top answer: Unfortunately there is no magic button. • Hands-on* testing will be required.
Does my PT Cruiser have a fuel reset button? I ran out of gas ...
Oct 29, 2012
where is fuel filter - 2008 Chrysler PT Cruiser - RepairPal
Oct 19, 2014
Won't start, tries to but does not turn over like its not getting fuel
Apr 7, 2011
Chrysler PT Cruiser Vehicles With This Problem - RepairPal
Mar 12, 2011
More results from repairpal.com

go have vehicle scanned most auto stores offer this service for free the code will advise you on what the problem is so repair can be made

Stephanie,

Try cleaning the battery connections, and have a load test performed on the battery.

Bad filter, no injector pulse (use noid light to check this), bad fuel pressure regulator (test pressure key on engine off).

sounds like the computer has picked up a problem within the system, have someone, or yourself hook up a obd 2 code tester retrieving tool , to the aldl, under the instrument panel, on the left side of the steering columb, in order to find out what the code problem is, then you can check that area out for the problem, " also, auto zone will hook this tester up for free.

mcdevito75 here, Yes a crankshaft sensor could cause your mentioned problems, the sensor should be located near the Harmonic balancer, you may need a special tool to remove it and if I'm not mistaken the new sensor thakes an adjustment, Have auto zone change this sensor for you, even if you succeed, how often will you change this sensor.

This light tells you that the engine or transmission needs attention. It's not going to blow up if you keep driving it for a little while, if it's still running (red lights, like oil pressure, mean to stop RIGHT NOW).

Just changing the oil is probably not going to make the light go out. The light was turned on by the engine's computer, and indicates that the computer got a bad reading from one (or more) sensors located throughout the engine and transmission. Most auto parts stores can hook up a code reader to your car and read the trouble code stored by your computer. The trouble code indicates what system is not working properly and that may tell you what to replace to fix it. Or it may require more in-depth testing to determine the exact problem.

it could be many things..... i would take it to auto zone parts store and have them hook it up to the computer..... then it will tell you what the problem is....

Go to Auto Zone and have the starter tested. If it's good, then it could be the starter solenoid or one of the starter relays.

Sounds like a re-occuring temporary code....take it back to the dealer or Auto Zone and have the code scanned within your 6 start reset limit