ABS & traction control just went out on 2008 Ford Escape.

You need a mechanic with a high level scan tool to check the Diagnostic Trouble Codes and Live Data. It is probably ABS Sensor related, but should never leave you with no brakes..

Hi Dear,

Please Check Following Link

http://modulemaster.com/rebuilds/instructions/ABS/Ford_Escape_ABS.pdf

Best of Luck
Dinu,...

check hub /wheel bearing and or brakes for damage or failure --also need to check the abs system which is incorporated into the hub
2008 Ford ESCAPE Traction Control System problems defects barely moving is possible your in limp mode --if drive able need to have scanned for trouble codes to see if its abs or other possible problem

PAGE 221 OF OWNERS MANUAL SHOWS LOCATION [UNDER HOOD]NUMBER 18 the following link is a copy of your owners manual
2008 Ford Escape Owner Guide 3rd Printing

Hello

The engine and the automatic transmission in this vehicle are computer controlled and in most cases when a fault occurs a fault code is stored in the memory of the computer control module. There are exception to this, such as the Mass Airflow Meter and fuel pressure problems. What must be done is to have all the basic testing done such as a scan of the system for fault codes as well as a check with a live data scanner tool for engine functions that are not within range of normal, a trained technician is required to know what is correct and what isn't, then based on careful diagnostics done from a factory repair manual the correct part is replaced or the wiring repaired or the computer replaced (known as the PCM), which is very rarely the problem. Other basic checks must be done as well such as mechanical problems with the engine as well as engine state of tune and mileage on the engine. The transmission can have mechanical issues as well such as no gear engagement at all or a failed pump or other pressure related problems.

2008 Escape has a terrible reputation for ABS light and traction control light being. All due to broken ABS tone ring cracked and out of position flopping on frt bearing. Go to local AutoZone store and they will scan this to find which wheel has the broken tone ring. The replacement ring is cheap in the $7 range. It is labor that will sicken you as this ring must be pressed on after the front half shaft is removed. Not a driveway job if you are considering DYI.

Have it checked for codes

You have an ABS System Failure

disconnect the wiring to the ABS module and see if it drains the battery overnight sound weird!

worn out pads or rotor, possible broken abs cable to brake. first check to see if all 4 are connected. all ore on back side of brake dust shield. than check to see if the brakes are worn last is the rotors. also see if there is a recall on the brake and battery re charge system.

Check this page. Very usefull for this problem.
http://www.ford-forums.com/ford-escape/43888-2006-escape-abs-4wd-light.html