20 Most Recent 2002 Ford Escape Questions & Answers


The easiest way to test if the wires to #6 are sending the signal to the injector is to get a noid light and plug it into the harness at the injector providing there is room to access the injector from the injector.

Often times, the positive voltage feeds all the injectors, while the PCM applies ground to each individual injector.

You will need to test continuity from the #6 injector to the PCM with an Ohm test providing you have 12 volts at the injector. The ground opens and shuts once with each intake cycle to provide a fuel charge, so it will blink rapidly. That is normal. If the noid light does not come on but you confirmed 12 volts positive, but no ground then you have an open between the injector and the PCM. If the noid light comes on but does not flash or flicker, then there's either a short to ground in the wire from the injector to the PCM, or a faulty driver within the PCM itself causing an internal short.

2002 Ford Escape | Answered on Oct 14, 2019


More tgank likely you'll have to remove a motor mount, at least on one side to shimmy the pan assembly out. Hope this helps

2002 Ford Escape | Answered on Sep 11, 2019


First check the fluid, add as necessary then return to the shop that did the work, it should be under warranty. I hope this helps. Take care.

2002 Ford Escape | Answered on Apr 27, 2019


The cables in the roof are probably damaged and rusted. Also some sunroofs only open half way. But you sound like it used to open all the way.

2002 Ford Escape | Answered on Apr 23, 2019


you can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete

2002 Ford Escape | Answered on Feb 15, 2019


A hatchback is a style of automobile in which the rear deck lid and window lift open as a unit. It's also called a liftback.
----------------------------------------------------------------

Heavy Duty Truck Diagnostic
Allscanner VCX

2002 Ford Escape | Answered on Sep 29, 2018


The YEL/WHT and BLK/YEL leads are hot. The LT GRN/RED lead connects to the charge indicator.

2002 Ford Escape | Answered on Sep 06, 2018


Hi. These SUVs are known to have a bushing failure that affects the shift cable. is the cable loose and sloppy? if so please inspect the end of the shift cable under the dashboard. If your issue is different and you need to adjust (recenter) the shift selections. The adjustment is a single 10mm bolt at the end of the cable, at the transmission. Easy. Loosen the bolt and slide the cable until the tension is neutral, tighten and test.

2002 Ford Escape | Answered on Aug 25, 2018


I would say that a premature bearing failure would be caused by a defective (cheap?) bearing, or improper installation. The axle nut is what clamps the bearing and sets the bearing preload. If the nut is under-torqued, the best bearings in the world will fail very quickly. The 2002 bearing is a Gen1 style cartridge bearing. It has to be pressed into the knuckle, and then the hub gets pressed into the bearing. It the bearing isn't properly support during the press operation, and is pressed across the balls, the balls or races will get damaged... bearing is done for.

2002 Ford Escape | Answered on Jun 29, 2018


2.0 or 3.0 L engine ? DPFE sensor . What code is stored ?

2002 Ford Escape | Answered on Feb 22, 2018


Did you replace the spark plugs? Did you do a tune up?
The gas may have condensation water if you didn't keep the tank full in cold weather. Try this and possibly add a cleaning agent for the clogged lines.

2002 Ford Escape | Answered on Feb 08, 2018


The switch is not working from defroster to front vents could be the vacuum problem or electrical.

2002 Ford Escape | Answered on Feb 06, 2018


There is no way to "turn it off." If you could, they wouldn't call it antitheft. Get the trouble codes read and fix it. This isn't a complicated system and is fairly inexpensive to fix.
Ford PATS Antitheft System Ricks Free Auto Repair Advice

2002 Ford Escape | Answered on Jan 22, 2018


worn out spark plugs can cause high resistance to coil packs and make them fail.try that first

2002 Ford Escape | Answered on Jan 15, 2018


Junk yard will have one for less but a chance roll the dice

2002 Ford Escape | Answered on Jan 14, 2018

Not finding what you are looking for?
2002 Ford Escape Logo

1,829 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Ford Escape
2001 Ford Escape

1,056 Questions

2005 Ford Escape
2005 Ford Escape

1,058 Questions

2003 Ford Escape
2003 Ford Escape

869 Questions

2004 Ford Escape
2004 Ford Escape

538 Questions

2006 Ford Escape
2006 Ford Escape

472 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Escape Ford

  • Escape Ford

Most Popular Question

test coils 2002 ford escape xlt v6 3 0

  • Cars & Trucks
Loading...