1998 Ford Windstar Logo
Posted on Dec 21, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Door chime wont stop - 1998 Ford Windstar

2 Answers

Marvin

Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

  • Ford Master 85,242 Answers
  • Posted on Dec 21, 2009
Marvin
Ford Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Top Expert:

An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

Joined: Jun 20, 2008
Answers
85242
Questions
28
Helped
29060532
Points
266281

Thgis problem is caused by one or more defective door ajar/courtesy light switches or sliding door contacts, since these switches are very hard to replace as they are located inside the doors on the door latch the best thing to do is have the dealer hook up a body module scanner, it can ID the faulty switch, then i f wish u can change it to save money, the switches are about $15 each, there are 5 of them

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

  • Contributor 2 Answers
  • Posted on Jun 18, 2012
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Joined: Jun 18, 2012
Answers
2
Questions
0
Helped
1908
Points
3

I just found out that the problem on our 1998 windstar was the chime switch attached to the ignition switch. This chime switch when dislodged will short and act as if the keys are still on when the door is open ( thus sounding off the alarm). I had a hunch that the problem was close to the steering wheel because the alarm would stop if I change the angle of the steering wheel a couple of notches up or down. I guess when i did that the chime switch that i'm pertaining to get reset to the right position and stops the alarm. when i opened up the steering wheel housing around the ignition , the chime switch fell, it had a blk wire I think, and I saw that the clips on it were kind of melted thus not sticking to its right position. I just had to remove the ignition switch for a while and replaced the chime switch with the help of a zip tie wrapped around it. then I placed everypart back together and no chimes... also I did this all while the battery was disconnected because i needed the ignition switch to be in the on position to get it off the steering wheel. Good luck guys!

Ad

3 Related Answers

rage-n-ron

  • 20 Answers
  • Posted on May 10, 2009

SOURCE: 1992 ford ranger door chime wont stop

Find it & unplug it.

Ad

Anonymous

  • 811 Answers
  • Posted on Sep 27, 2009

SOURCE: Door chime wont stop

open door push switch by hand, if it does adjust switch

Anonymous

  • 22 Answers
  • Posted on Feb 13, 2010

SOURCE: location of door chimes module

one of the doors is not closed completely or...... the button is stuck in the depressed position. try each door one at a time, shut each firmly and check the result or................ look inside the door frame when the door is open to see if the button is popped out(there is a button that looks like a stem in the door jam towards the hinge end of the door). if you find one that is stuck (pushed in as if the door was closed) then pop it out with your finger or small screw driver and then lubricate it with a few drops of oil.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why does my Carlon Plug in Chime Model RC8253R keep going off?

Carlon Plug in Chime Model RC8253R?? What is this?
0helpful
1answer

06 montana chime wont stop out of park all doors shut tight

Might have a door switch bad is bad or wiring to one of the switches. I would begin by checking if there are any blown fuses. Would then check wiring to each door, along frame inside a rubber boot where door hinges are. If wiring is all good, I'd then move on to removing door panels and disconnecting each door latch harness until the chime goes off. This will indicate the specific switch that is bad. If all are good.
0helpful
1answer

Stop the annoying door chime on a 1997 Mitsubishi diamante

take the annoying door chime module out , its right there in the fuse box (use your hearing to zero in on it), but ill warn you now then you wont anylonger have the annoying chime you left your lights on and your battery will be dead .
0helpful
1answer

Chime wont stop

take it out lol or replace it
5helpful
1answer

How to turn off door chime 2006 buick terraza

how can I get the door chime to stop working when I put my 2007 terraza indrive it gose off and wont stop the only thing I did was disconnect the negative batter cable to do some work and when I put it back on this is when it started. can someone please help thank you
1helpful
3answers

My door chime wont stop ringing when the driver side door is open and the keys are out of the ignition. how can i fix this?

I just found out that the problem on our 1998 windstar was the chime switch attached to the ignition switch. This chime switch when dislodged will short and act as if the keys are still on when the door is open ( thus sounding off the alarm). I had a hunch that the problem was close to the steering wheel because the alarm would stop if I change the angle of the steering wheel a couple of notches up or down. I guess when i did that the chime switch that i'm pertaining to get reset to the right position and stops the alarm. when i opened up the steering wheel housing around the ignition , the chime switch fell, it had a blk wire I think, and I saw that the clips on it were kind of melted thus not sticking to its right position. I just had to remove the ignition switch for a while and replaced the chime switch with the help of a zip tie wrapped around it. then I placed every part back together and no chimes... also I did this all while the battery was disconnected because i needed the ignition switch to be in the on position to get it off the steering wheel. Good luck guys!
1helpful
1answer

Dodge 1996 car

sounds like one of the courtesy light switches in the one of the doors is faulty
3helpful
1answer
Not finding what you are looking for?

958 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...