Car jerks on freeway and engine shuts off.

Yes there are

2 Recallsfor 2005 NISSAN ALTIMA

• Summary. ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.
• Remedy. DEALERS WILL REPROGRAM THE ECM FREE OF CHARGE. ...
• Notes.

2005 NISSAN ALTIMA 4 DR ' NHTSA

2005 Nissan Altima Recalls ' Cars.com

www.cars.com > research > nissan-altima-2005 > recalls

CERTAIN TYC HALOGEN TYPE HEADLAMP ASSEMBLIES P/N 20-6644-00 SOLD AS AFTERMARKET EQUIPMENT FOR 2005-2006 NISSAN ALTIMA ...

2005 Nissan Altima Safety Recalls - Autoblog

www.autoblog.com > ... > Altima > 2005 Nissan Altima

SUMMARY. ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A ...

2005 Nissan Altima Recalls ' RepairPal

repairpal.com > 2005-nissan-altima > recalls

Sep. 22, 2020 - Most Recent 2005 Nissan Altima Recall On certain passenger vehicles equipped with a 2.5l engine, the crankshaft position sensor can overheat causing a brief interruption in the signal output from the sensor. 2005 Nissan Altima Reviews and Owner Comments - RepairPal
Oct. 15, 2020
2006 Nissan Altima Recalls ' RepairPal
Sep. 24, 2020
2004 Nissan Altima Recalls ' RepairPal
Sep. 23, 2020
Nissan Recall 07V527000: Overheating of Crankshaft Position ...
Dec. 31, 2007
More results from repairpal.com

2005 Nissan Altima Recalls & Safety Notices ' Kelley Blue Book

www.kbb.com > nissan > altima > 2005 > recall

Almost 350,000 Nissan Altima vehicles made between 2015-2017 were recalled dealing with an improper rear door latch. Lowering a rear window could ...

Not fuel filter. Is your engine light on? Could be accelerator pedal position sensor. Does it do it only when you are accelerating?

nothing in most cases

P0725 NISSAN - Engine Speed Signal

The P0725 Codes is triggered when TCM does not receive the engine speed signal from ECM.

The Engine Control Module (ECM) monitors the engine speed through the Crankshaft Position (CKP) sensor with the engine running, and send signal to the Transmission Control Module (TCM).

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes:
- Open or shorted CKP sensor circuit condition
- Poor CKP sensor electrical connection
- Check communication error between the ECM and TCM
- Failed CKP Sensor

Possible solution:
Very common problem with Nissan vehicles, usually replacing the Crankshaft Position sensor takes care of the problem.

Keep us updated.

If it has a code for loosing the crankshaft position sensor signal, I would certainly start looking at that before venturing into the fuel system. Cam and Crank sensors are a common failure item for Nissans of that era. Nissan actually redesigned the sensor and i think they performed a recall on some vehicles. They are fairly inexpensive and easy to replace. I believe they run about $40 each. Because most people don't have access to a powerful scanner or a digital storage oscilloscope to verify the failure I recommend replacing the cam and crank sensors at the same time.

2005??? dealer only encrypted software so a plug in scanner will read the wrong code .From description try changing the coil pack

CPS - Crankshaft Position Sensor; common problem.

the 2.5 altima's had a recall on that problem about 2-3 years ago. Go to edmunds or progressive find the recall letter and the dealer will fix it free. well here you go:

Recall ID # 07V527000 - ENGINE AND ENGINE COOLING Recall Date: NOV 14, 2007 Component: ENGINE AND ENGINE COOLING Model Affected: ALTIMA Potential Units Affected: 653910 Recall Details Recall Date: NOV 14, 2007

Model Affected: 2005 NISSAN ALTIMA

Summary: ON CERTAIN PASSENGER VEHICLES EQUIPPED WITH A 2.5L ENGINE, THE CRANKSHAFT POSITION SENSOR CAN OVERHEAT CAUSING A BRIEF INTERRUPTION IN THE SIGNAL OUTPUT FROM THE SENSOR.

Consequence: IF THE INTERRUPTION IN THE SIGNAL FROM THE CRANKSHAFT POSITION SENSOR IS SO BRIEF THAT THE ELECTRONIC CONTROL MODULE (ECM) LOGIC DOES NOT HAVE TIME TO DIAGNOSE THE CONDITION, THE ENGINE MAY STOP RUNNING WITHOUT WARNING WHILE THE VEHICLE IS DRIVEN AT A LOW SPEED INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL REPROGRAM THE ECM FREE OF CHARGE. CERTAIN MY 2006 ALTIMAS WHICH HAVE BEEN PREVIOUSLY REMEDIED UNDER RECALL CAMPAIGN 06V223 (NISSAN R0606) ARE NOT INCLUDED IN THIS RECALL SINCE THE REPROGRAMMING FOR 06V223 ALSO INCLUDED THIS REPROGRAMMING. THE RECALL BEGAN ON DECEMBER 31, 2007. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.

Potential Units Affected: 653910

Notes: NISSAN NORTH AMERICA, INC.

Probably sensors! I have already replaced the crankshaft positioning sensor once, nissan replaced it once under recall and now it is bad again! Plus my speed sensor is bad too! Go to any part store and get diagnostic test ran, it will tell what sensors are bad.

Its right next to the passenger side drive shaft, where it goes into the transmission. Right above the drive shaft. It s black with green slider inside of the connector and it has 3 wires coming out of it.