Turn off warning light - Cars & Trucks

The Enhanced
Traction System
warning light may
come on for the
following reasons:


If you turn the system off by shifting to SECOND (2)
or FIRST (1), the warning light will come on and stay
on. To turn the system back on, shift to THIRD (3) or
AUTOMATIC OVERDRIVE (
). See “Enhanced
Traction System” in the Index.


If the Enhanced Traction System warning light
comes on and stays on for an extended period of
time when the system is turned on, your vehicle
needs service. Adjust your driving accordingly.


The warning light will come on when you set your
parking brake with the engine running, and it will
stay on if your parking brake doesn’t release fully.
If the transaxle shift lever is in any position other
than FIRST (1) or SECOND (2) and the warning
light stays on after your parking brake is fully
released, it means there’s a problem with the system.


If the traction control system is affected by an
engine-related problem, the system will turn off
and the warning light will come on.

The electronic switch on the top of the fuel filter housing is the fuel filter warning switch.
To reset the warning light on the cluster you need to do this:
1. With the ignition switch off, disconnect the fuel filter warning switch connector.
2. Turn the ignition switch from off to ON.
3. After more than 3 seconds but less than 60 seconds have elapsed, reconnect the connector.
4. After approximately 3 seconds have elapsed with the fuel filter warning switch closed, the
system confirms the deletion of the illumination information by turning off* the warning light.

Check this link for all Nissan warning lights

Nissan Altima Dashboard Warning Lights and Meanings

The Nissan Master Warning Light, Explained
Basically, all the master warning light does is let you know that there's some other warning you should pay attention to. According to the 2015 Nissan Altima owner's manual, when the ignition is in the ON position, the master warning light will turn on with any of the following warnings:
-Loose fuel cap
-Door open
-Trunk open
-Low fuel
-Low windshield wiper fluid
-Check tire pressure warning
-No key detected (happens if the Nissan Intelligent Key is left outside the vehicle)
-Release parking brake (this should occur any time you start the car after setting the parking brake)
If your Master Warning Light comes on, please contact your local Nissan Dealer

The chime is going off to alert you to the charging system problem, have it tested.

My brake lights won't turn off Help!!!!! - Club Lexus Forums

www.clublexus.com/.../592044-my-brake-lights-won-t-turn-off-help.ht...

Sep 13, 2011 - Join Date: Oct 2010 ... there is a switch on the brake pedal that operates the brake lights, ... take a look. my hope is it helps people get into their Bible where the Holy Spirit can teach them the REAL truth, not my words, which are .... 400/ 300 Classifieds (98-05), RX350 / 330/ 300 / 400H / 450H Classifieds ...

Rear Brake Light Dash Warning Won't Turn Off - Club Lexus Forums

www.clublexus.com/.../468853-rear-brake-light-dash-warning-won-t-tur...

Dec 9, 2009 - Rear Brake Light Dash Warning Won't Turn Off SC- 1st Gen (1992-2000) ... Do you have the correct tail lights for your model year? Do you a ...

[PDF]List of Warning/Indicator Lights - Lexus Drivers

Probably bad switch and short with warning lights. Or this is a
warning system of big problems. Owner's manual should tell
you what is happening with the warning light system.

Please provide more information.

"I put the key in the ignition, turn it and the warning light goes out, I turn the key to start but there is nothing..." or

"I put the key in the ignition, turn it and the warning light goes out, I turn the key to start but there only a ticking/clicking sound..." or

"I put the key in the ignition, turn it and the warning light goes out, I turn the key to start but the engine only turns over and doesn't catch."

This sometimes is triggered by the MAF(Mass Air Flow Sensor), try cleaning it with the highest percent isoproply alcohal first, do not touch the sensor with anything use a big bag to soak it into, or just replace the sensor.

There is a procedure in the owners manual on page 110.

BeltMinder activation and deactivation procedure
1. Turn the ignition switch to the RUN (or ON) position. (DO NOT START THE ENGINE.)
2. Wait until the safety belt warning light turns off. (Approximately 1–2 minutes.)
• Steps 3–5 must be completed within 60 seconds or the procedure will have to be repeated.
3. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This can be done before or during BeltMinder warning activation.
4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.
5. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled
• After step 5 the safety belt warning light will be turned on for three seconds.
6. Within seven seconds of the safety belt warning light turning off, buckle then unbuckle the safety belt.
• This will disable BeltMinder if it is currently enabled, or enable BeltMinder if it is currently disabled.
7. Confirmation of disabling BeltMinder is provided by the safety belt warning light flashing four times per second for three seconds.
8. Confirmation of enabling BeltMinder is provided by:
• The safety belt warning light flashing four times per second for three seconds.
• Followed by three seconds with the safety belt warning light off.
• Once again, the safety belt warning light will flash four times per second for three seconds.
9. After receiving confirmation, the deactivation/activation procedure is complete.

If you did not get an owners manual with your truck ( purchased used ), you can download one from Ford :
https://www.fleet.ford.com/maintenance/owners_manuals/default.asp

From the F-150 Forums, since I just bought one and this worked!

This is straight from my 2009 f150 owners guide

Preperation
1. the parking brake is set
2. truck in park
3. ignition switch is in off position
4. both seat belts are unbuckled

Disable Belt-Minder
1. turn the ignition switch to the on position, DO NOT START THE ENGINE.
2. wait until the safety belt warning light turns off. (approximately 1 minute).
* step 3 must be completed within 50 secs after the safety belt warning light turns off.
3. buckle then unbuckle the seat belt nine times, ending in the seat belt unbuckled.
* after step 3 the restraint warning light, (airbag light) will turn on for three (3) seconds.
4. within approximately seven (7) seconds of the light turning off, buckle then unbuckle the safety belt.
* the restraint system warning light will flash four, (4) times per second for 3 seconds for confirmation

you can do this for the passenger side also!!!


*NOTE
in step 3. after three times buckling and unbuckling the restraint warning light lit up in my truck. SO I WENT TO THE NEXT STEP, (STEP 4). waited 3 seconds and i buckled and unbuckled.

in the buckle /unbuckle procedure do it some what slowly and watch for the light. it may not take 9 times.
__________________