SOURCE: alarm immobillizer
The alarm systems on land rovers are quite tempramental. They work on radio frequencies. If you park next to a radio antenna like they have at post/ telecommunications offices. Then the radio waves they send out can interfere with your cars system, making it think it has been attempted to be broken into, and so immobilises. You should have a 4 digit code called the EKA code. You must have this to knock off the immobilser to start the car. The car must be locked completely, all windows shut and then enter the EKA code using your key.
Hope this helps
SOURCE: I dont know where to hook up immobileizer bypass wire
An immobilizer bypass is an electrical circuit which allows current to flow to whatever component is starved of current to keep the engine from running (usually the coil). The immobilizer opens the circuit to the coil, the immobilizer bypass closes the circuit to the coil.
If you didn't install an immobilizer circuit, then you don't need the bypass. There are probably instructions you missed in the manual explaining the immobilizer circuit.
SOURCE: immobilizer
If there is a blinking car icon with an "X" over it. This icon means the Immobilizer has been activated and hence won't allow the car to start. It could be due to a bad SCU, Start Control Unit. The SCU is actually the ignition switch on these cars.
Most of the time it's triggered by the anti-theft system..You can try this trick i learned that the dealers won't tell you...try locking and unlocking of the doors five times with the remote to reset the immobilizer and see if this helps.
Good luck..i hope this helps...please take a minute to rate me a fixya.
SOURCE: alarm and engine immobilizer system
Tha t option is not enabled. You are equipt with it. Here the solution you need a scan tool the can read anti theft data, Obviously the key is not enabled, The version you have is world wide,
824 views
Usually answered in minutes!
×