In doing myself so need advice
Https://s28.postimg.org/mzupjlzfx/removal.jpg
Click on the link.
Found this info in my database.
Step number three says to remove front bumper cover. If you see a better way, use your best judgement. Sometimes the database procedures are not the easiest or quickest, it just depends? I have no experience on your particular vehicle.
SOURCE: How do I replace xc90 headlight assembly?
its really easy. Open the hood, you will see two metal flat bars on the backside of each headlight, holding the headlight assembly on. Pull up on each of them.... remove headlight. Ta da.
SOURCE: replacing front bumper on 1999 buick regal
7/16th or 10mm Sheetmetal nuts All over Behind the Bumper Thak Bumper off first
SOURCE: Bumper cover removal
It is a little more complicated than that. There are two nuts below the headlight assemblies in the engine compartment. You will need to remove the battery and overflow bottle to get at the one on the passenger side. Remove the turn signals in the bumper, then there are 2 or 3 bolts holding a mounting bracket behind the each of the turn signals. There are a number of bolts with washer heads and reatiners on the underside of the bumper as the previous responder indicated.
SOURCE: remove 2007 jeep compass bumper cover
Hello, I can assist you. Begin by rounding up the necessary tools:
7mm socket and ratchet
7mm wrench
10mm socket
screw driver or panel removal tool (for push rivets)
Now go to the following site and take a look at the step by step instructions and pictures which does a nice job of explaining this entire job. Thanks for using Fixya!
http://www.jeeppatriot.com/forum/showthread.php?t=6291
SOURCE: I have an 02 Mazda Tribute with a leaking Radiator
1. Drain coolant
2 Remove lower splash shields
3. Disconnect the lower radiator hose and the high pressure transaxle line
4. Lower the vehicle
5. Disconnect the transaxle return line
6. Disconnect the upper radiator hose and degas hose
7. Position the hood latch assembly out of the way
8. remove the 2 bolts and the center support
9 remove the 2 top bolts retaining the cooling fan to the radiator
10. remove the upper radiator support brackets, and remove the radiator from the vehicle
11. To install, reverse the removal procedure
390 views
Usually answered in minutes!
×