I have a 2001 pt crusier. My turn signals work but none of my gauges work. They did wotk but just stopped one day.The fuse for the dash is fine. Anyone know what it could be?

There could be a few potential causes for the dash gauges not working on your 2003 Honda Civic. Here are a few things to check:

1. Check the battery connections: Make sure the battery terminals are clean and tight. Loose or corroded connections can cause electrical issues.
2. Check the ground connections: Make sure the ground connections for the dash gauges are clean and tight. A bad ground connection can cause electrical issues.
3. Check the voltage regulator: The voltage regulator is responsible for regulating the voltage to the gauges. If it's faulty, it can cause the gauges to stop working.
4. Check the instrument cluster: It's possible that there's an issue with the instrument cluster itself. You may need to have it inspected by a mechanic.
5. Check for a blown fuse: Although you've checked the fuses already, it's possible that one of them has blown. Double-check the fuse for the instrument cluster to make sure it's not the issue.

If none of these solutions work, it's best to have a professional mechanic diagnose and repair the issue. They will be able to use specialized tools and equipment to identify the problem and find a solution.

There should be 6 relays in the fuse box. Using your manual, find the turn signal relay and replace it.

None of my gauges will work, but my turn signal indicators ...

www.americanautowire.com/.../none-of-my-gauges-will-work-but-my-tu...

None of my gauges will work, but my turn signal indicators, high beam ... As we've discussed previously, anything electrical needs a 12 volt feed and ground to work. ... 09/28/2015 There are a number of new products coming in Nov/Dec this ...

my gauges quit working - CarGurus

www.cargurus.com > Questions > Ford > F-250 Super Duty

CarGurusSep 21, 2013 - my gauges quit working - My odometer, speedometer, fuel, tach, trip, and ... I tried fixing the wire and had the same problem....so I replaced the shift lever and everything is back to ... no gauges will work in dashboard 1 answer.

No dash gauges, but dash lights - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Dodge > Caravan ' Voyager

Feb 6, 2010 - The dash lights work fine, so does everything else. The dash gaugesjust don't work. This is something that has been an intermittent problem ...

Do you have power on all of the fuses in the passenger compartment and the box near the battery ?

make sure the battery is charging, make sure the alternator is putting out correct amp/volts, check cable connections of battery - at both ends, check connections of harness at back side of fuse boxes, check harness connection block at firewall (both sides of firewall)
, check harness connections leading up into underside of dash.
Ensure all ground connections are tight and not broken.

You will need multimeter and probe tool with light.

2001 Chrysler PT Cruiser 2.4L SFI DOHC 4cyl

Fig. Combination Flasher (2001)

Fig. Combination Flasher (2001)


I hope helps (remenber rated this).

Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.

I fixed the problem. A fuse had burned out. Find the Fuse Box under the hood and replace fuse #3.
The fuse that I purchased had a darker green color, which you can see on the below picture (Upper Row; If you start from the right, it will be the third fuse).

The motor is gone and the switch could be gone too.

I would replace both to be on the safe side.
The switch is not that expensive. The motor is more expensve.

Could br the light switch is bad.