SOURCE: 93 mazda protege clutch repair tips needed
to take out your drive shafts you first need to drain oil from gearbox.plug is on the bottom of box.when this is done remove wheels..take off your disc caliper (2 bolts).tie them up out of way.remove disc rotor(should just slide off).then you need to remove split pins from your steering rack(tierod).. 2 bolts where the part bolts to the strut.next is at base (lower control arm).you will see a bolt and nut(this will be tight to get out use a soft punch like copper or brass shaft to knock bolt out.dont damage thread).to replace this you have to make sure it sits in the right place or you will damage thread when you fit the bolt...when all this is done the hard part comes.the drive shaft is very tight in the gearbox due to a spring type circlip on the axle shaft.you have to wrench the shaft towards you to free it .some times you may have to get a very solid big flat screwdriver in between the gearbox and shaft to loosen past the clip.when it is free ,just slide out.when you have done what you need to do.assembly is just reversing whatyou have just done . to fill gearbox up you have to take out the speedo cable and speedo drive from the gearbox (at back off motor,1 little bolt).top up .you have a mark on the drive to tell you the level.hope this helps (have fun)
SOURCE: lighter
check the fuse first. on most cars the horn and cigar lighter are on the same circut.
SOURCE: i replaced the water pump and radiator in my 93
wwhere is the location of the thermostat on a 93 audi cs 100 quattro
SOURCE: where is the fuel pump on a mazda protege 93?
The fuel pump is in the fuel tank. You have to remove the tank to get the pump out. I would check the fuel pressure with a gauge to make sure the pump was out just to be sure. Changing the pump is a lot of work, and checking the fuel pressure will let you know if you need a new pump.
41 views
Usually answered in minutes!
×