My REAR AMPS ARE NOT WORKING ITS A 01 MUSTANG GT HAS THE 460 SYSTEM AND DO THEY HAVE OWN FUSES IF SO WERE ARE THEY

check the operation of the bass control someone might have turned it down the amp is built into the radio

i can rewire the back lights to europeon standard but the speaker wires?' try using a multi meter on teh wires you suspect and see if you have a current with the radio on

Interior lamps are powered through fuse # 7 and is a 15 amp fuse. It is located in the interior fuse panel. The lamps are gounded though ground # G400 which is located in the left rear cargo area.

Not sure if the Radio is even turning on or what kind you have as there are a couple. Heres the info I can give you though. The radio (start) fuse is in the number 20 position (20 amp) in the fuse box inside the car located on the passenger lower side behind the kick panel. Remove the trim panel and the fuse cover to access the fuses. A diagram for that fuse is below. In power distribution box located in the engine compartment are 3 other fuses depending on which radio you have. in the number 6 & 7 position are the fuses for the rear amps on the shaker 1000 radio and in the number 16 position is for the front amp if you have the shaker 500 radio. All those fuses are 30 amps. See the diagram for that fuse box below as well.

both power seats are controlled by a 25 Amp MAXI fuse in the under hood fuse center, it is located to the rear of the battery, the fuse is marked "Power Seats"

go to your local junk yard, plenty of must to choose, the parts at half price

please rate highly if this is what you need

Section 01-10: Seats and Tracks 1994 Mustang. Workshop Manual
REMOVAL AND INSTALLATION Seat Cushion, Rear Removal and Installation

1. Release pin from locks by pressing release button under rear seat cushion.

1. Pull rear safety belt and buckle (60044) through openings in rear seat cushion pad and frame (600A88) and remove rear seat cushion pad and frame .

1. To install, reverse Removal procedure.
   

----------------------------------------------
Section 01-10: Seats and Tracks 1994 Mustang. Workshop Manual
REMOVAL AND INSTALLATION Seat Back, Rear Sedan
Removal

1. Remove rear seat cushion as outlined.

1. Remove rear seat bolster. Refer to Section 01-05 .

1. Remove rear seat bolster mounting bolts. Remove bolster assembly.
2. Remove four seat back to package tray retaining bolts.

1. Remove seat back.

1. To install, reverse Removal procedure.

check your amplifier mustang with 460 mach stereo have aplifiers in the trunk behind or it may be a fuse

there are three amps. One is in the front in the dash board. The other two can be accessed through the trunk in the very back. You have to remove the two side panels first and then there are screws or some kind of bolts on the top of the back panel holding the back panel in place. Remove that you'll see in the center your motor to your convertible top and on the side your two amps.

if you have any questions just email me... [email protected]

good luck,

brandon

Start with the basics check fuse #29 it should be a 15 amp fuse. Lets start with the basics. Let me know how that goes.