Need diagram for cooling system, hose flow and locations 2006 charger 5.7 hemi

Powertrain Control Module (PCM)/Starter

Dodge Charger (2006-2010) fuses

Fuse-Box.info https://fuse-box.info > dodge > dodge-charger-2006-2...

The fuse box is located in the engine compartment. The location of the fuses in the engine compartment: Dodge Charger (2006-2010. Front Power ..

You need an auto electrician. The pro grade scan tool computer will diagnose the issue.

https://www.google.com/search?q=mobile+auto+electrician+near+me

..

In the link

https://www.google.com/search?q=diagram+for+cooling+system+2006+Mazda+3

..

5.7L Engines

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect negative battery cable.
3. Drain the cooling system.
4. Disconnect negative battery cable.
5. Remove the upper radiator hose.
6. Disconnect cooling fan electrical connector.
7. Remove cooling fan mounting bolts.
8. Remove the radiator cooling fan assembly from vehicle.
9. Remove the radiator fan assembly.
10. Remove accessory drive belt.
11. Remove thermostat.
    NOTE The water pump mounting bolts are different lengths. Note the location of the water pump mounting bolts.
    

To install:

1. Install water pump and mounting bolts. Tighten mounting bolts to 20 ft. lbs. (28 Nm).
2. Make sure double ended bolt is in the proper location. Tighten double ended bolt to 20 ft. lbs. (28 Nm).
3. Position the radiator cooling fan assembly in vehicle.
4. Install cooling fan mounting bolts. Tighten to 50 inch lbs. (6 Nm)
5. Connect the cooling fan electrical connector.
6. Install the upper radiator hose.
7. Install thermostat.
8. Install the accessory drive belt.
9. Install the radiator fan assembly.
10. Connect negative battery cable.
11. Fill the cooling system.
12. Pressure test cooling system.

follow the lower radiator hose to the engine,you have to raise vechicle to see thermostat it is under the vechicle,the thermostat is in the housing where hose go to thermostat housing bolted to the engine, you need to remove hose.if you have the HEMI ENGINE follow top radiator hose to thermostat housing behind the AC COMPRESSOR.

replace the dole valve..it is a valve that closes for max AC operation, located in line on on 1 of the heater core hoses near the rear of the block.

on my 2006 dodge 2500 hemi my o2 sensor wires got pulled out of conector need help on were the go back in.

1 8 4 3 6 5 7 2
2004 Dodge RAM 3500 4WD
5.7 liter Hemi V-8 VIN "D"

Belt diagram for 5.7 and 6.1 is the same i'll send a diagram hope you get it... good luck

sounds like you removed your heater core hoses. Put them back on.

1. check the battery first

usually the battery run down.