Battery was dead, changed it out and lights were flashing, will crank but wont start, has fire and the fuel pump is working
Check engine bay relays and fuses
might have a starter relay on that one
if all good
next
if the engine light is on
control module,immobilizer or ECU fault
that 1998 should have a diagnostic reader plug in
to find out why it wont fire
You need to clear the codes first. Check fuel pressure.
Hello
The engine
and automatic transmission in this vehicles drive train
are fully electronically controlled by a computer called the PCM
(Power Train Control Module). Whenever a problem like this occurs the
computer stores a record of the problem (there are of course some
exceptions to this, like the fuel pump, engine coolant temperature
sensor and MAF sensor for instance) in the form of a fault code in
its memory, to read these fault codes you must have the systems
memory scanned with a special tool. Once the fault code(s) are read
you then must perform the appropriate diagnostic testing to find and
resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A
TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPEDING YOUR
HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM
367 views
Usually answered in minutes!
×